I have the same issue the stain is not as wide , it’s intermittent. Don’t know if it’s the first page ? I’ve replaced the drum. Next the belt , but it was a 308 belt , wrong one . So this time I...
Type: Posts; User: dave novak
I have the same issue the stain is not as wide , it’s intermittent. Don’t know if it’s the first page ? I’ve replaced the drum. Next the belt , but it was a 308 belt , wrong one . So this time I...
I’ve experience the arms being out of alignment, seems like the belts are skipping on the drive teeth? My finisher is past the production serial number, for the updates. The last thing I tried was...
Konica has a bulletin on wrinkled envelopes
Hi folks
i covered the little yellow dots on the check w/ a sticky note and it works !😆
Maybe its the 2 one way gears on the front of the finisher, and shafts.
Hi make sure the seal that the dv unit sits on is not damaged, this will cause low suction of toner mist. Of course make sure the suction fan & filter are clean & working. They are just to the right...
the BH600 has 1.4 mil. on it. some of are techs are convinced that it's the paper. the first side lays flat the second side glues it's self too the drum? I will check and clean that ground, and the...
after doing everything said. i found that increasing vr 702 on the hv pcb. be carefull too much will give you a code. also go too the charge settings and increase the transfer voltage too 110.. GOOD...
hope this site will help me as well as you. i'm having issues with drum rap jams on the second side of copy. Biz Hub 600 seems to happen with bosie paper. please help.