got it. the copier is getting replaced with a loaner. Due to the lack of time in the office to do all checks and adj. we are looking forward to having it inshop. The customer has no patience as the...
Type: Posts; User: repairman
got it. the copier is getting replaced with a loaner. Due to the lack of time in the office to do all checks and adj. we are looking forward to having it inshop. The customer has no patience as the...
update on c3200 offset.
with many of the checks and resets done we now have a smaller offset and lighter as well.
The c2 did not allow us to run calibration. would not read anything we put on...
Thanks Teckat. I should have the greyscale. Get back on this
Canontech: The ITB has been replaced and dcon / gradation done as mentioned earlier but thanks
sample images atached
dcon clear and reset factory values
full gradation adjust
Black copy mode and prints are good
color mode and ps test print shows offset
Thanks Tekat that was more than helpful.
I will report back on this. The fact they can open then close the fuser section and it works for a while has me leaning to the itb drive and the dcon...
He said it looked about 2 or 3 mm
Sounds good. will do.
we may pack a parts machine in the van to this call. Have you seen any drive related failures causing offset?
C3220 with offset image in black or color modes.
if you open and close the fuser section it resets to normal for a day or so then gradually gets worse.
I have not been out to this copier yet due to...
Thanks and I did order from nationwide. good deal and exchange program really helps. $270 exchange
I believe we have that software still. Get back soon as we check stock.
Ok well it was the main controller. swapped out the whole assembly, it worked so I started swapping out everything attached to the controller. Just a bad board.
Anyone know someone beside Hytec...
Thanks for the info. I will be heading back out with a few pcb's in tow and see what happens.
Much appreciated!
Hello. I have an ir 5065 with a black or unlit touch screen. Copier acts like its in sleep mode. cycles up, has power light on panel.
over the weekend the customer had someone move the copier from...