3.15.2 Registering the number of punch holes
This operation registers which puncher unit is attached to the IC on the punch driver PCB so that the
puncher unit can be identified by the finisher....
Type: Posts; User: scotjohn
3.15.2 Registering the number of punch holes
This operation registers which puncher unit is attached to the IC on the punch driver PCB so that the
puncher unit can be identified by the finisher....
Red dot 3 line CCD Yellow dot 4 line CCD, sounds like if you have put the wrong scanner firmware on if so you will need the jig to overwrite you will not be able to recover with USB.
Also check you have reconnected drum thermistor.
Is that a USB connection you have going into copier ?
How many copies has machine done ?
Files on usb should be
1
2
3
dlFirmWare_352_452
FirmImage0.bin
FirmImage1.bin
FirmImage2.bin
mentusb.o
I think you are getting close to cracking this, As i know there is a setting in top-access to restrict scan to e-mail to addresses that are only stored in the address book.
setting of previous...
sending either emails or faxes to Address destinations only and reset them all to 0. 08-8704
08-9299
08-3848
08-3849
could be the top half of the front door is not making the microswitch , open front cover and cheat the front door switched.
You could also turn off Super-sleep mode in Topaccess.
Try putting labels on the by-pass and set as "thick 2" you should have no problems then.
thanks for your feedback
i'm having trouble with very intermititant error 545, printer lasts between 5 to 15 days before it codes out again (200 to 900 prints)
relpaced
Fuser unit
BCU
power supply
fuser harness...
08-549 SET TO 1
08-551 SET TO 1
08-552 SET TO 1
08-553 SET TO 1
08-554 SET TO 1
08-555 SET TO 1
08-556 SET TO 1
08-557 SET TO 1
08-559 SET TO 1
Check and set all these codes this will switch...
one of the reasons this happens is that the IQ sensor has been switched off that would explain why the copies are so "rich".
check 05 mode switch sensor back on and 396 will recalibrate.