No. Quello è un unidirezionale. Saluti da Milano
Type: Posts; User: acusso1234
No. Quello è un unidirezionale. Saluti da Milano
https://www.copytechnet.com/forums/konica-minolta/131702-c454e-df701-2nd-side-scanning-issue-post739264.html?highlight=#post739264
C280 and C360 only K. C284 and C364 has developer in all colors.
Hi you all.
I was asked from the IT specialist of one of my customers , to find a way to disable the possibility to wiew the job log who contains the domain names of the users.
Disabling PSWC...
Usually, inserting a little switch between the printer and the network helps.
Done that in a similar situation years ago. A C224e won't print or scan intermittently.
After firmware and driver the...
Tried that today on a C658. An half of the image read by the internal CIS was grayed.
Many thanks for sharing the solution, it worked!
After inputting the 145 go to the last item, enlightening it and press the right arrow.
Input 2 and touch fix. You'll see some of the zeroes became ones.
Exit from service mode and cicle power.
Keep filters clean. Expecially the one located near the Main switch and the other under the left plastic cover. You can also cut a little the foam glued on the little convoy who touch the waste toner...
Recently a Mono 754 had that exact jam code.
The first third of the A4 60gms paper was hitting a toner build-up hidden into the duplex unit. Disassemble is a joke.
Never heard back that...
Hello guys. Am I the only one who noticed the blue stripe near the top of the sample?
Time to swap/change the Cian drum/imaging unit. (done technical course years ago and decided that this dog is a...
Are you sure?
I have a bizhub 287 asking for a new drum.
Do not display is the choice in service mode.
Manual states that there are two settings via soft switch to change also. Tried that but no...
I can swap the board because they have a second identical machine. If the problem follows the board..If not I can swap the complete feeder.
Usually it is a standard A4.
Thanks for your answer and wish!
Hi all. I have to go to see this recently installed C658 that is producing copyes and scans with a problem at the side of the output readed from the CIS contained into the document feeder.
So,...
I've had a similar issue on a 754/fs535SD with over 2 millions printouts mainly used for booklets. A metal support located in the centre of the SD unit was broken at one of its ends. Can't provide a...
I've swapped the wiring using one coming from a bad one. Then installed a new chip
Yes, they are. No firmware required. Done that from a donour C224e to a 224e
A broken last gear on the cian dev unit can cause that. The printer does not error
while it isn't producing blue at all.
https://it.1day-1product.com/products/magic-fix
problemchild
Bizhub 227 will not print.
No Rj45 lan jack lights. no error or codes in service call information. Move to different drop problem continue, hooked up laptop on both straight and...
Hi. You can try the bizhub 211.It was the upgrade for the 210. So it is newer and drivers supported.
Make sure to choose the GDI driver, because on both machines PCL was optional and needed a board.
http://www.copytechnet.com/forums/konica-minolta/115504-transfer-all-address-book-settings-accounting-4-series-4-7-8-ser.html?highlight=
Registration roller bushings?
sysadm
Customer reported about a noise and than the code.
Maybe searching a broken gear is a good starting point.
Thank you, copyrooks.