I got one after much thought. It's great, in fact I am on it now, all manuals on it, brochures for sales, copy tech net when stuck all with no boot up. It also distracts customers when things get...
Type: Posts; User: Tactiveboy
I got one after much thought. It's great, in fact I am on it now, all manuals on it, brochures for sales, copy tech net when stuck all with no boot up. It also distracts customers when things get...
I would check the second transfer connection there is a tech bulletin about this. Basically you adjust the door to put more pressure on the connection.
Got it sorted now found a bulletin about the internal door adjustment which causes 2nd transfer problems, followed it hey presto!
Hello,
We have an ineo+220 which has been fine but has now started producing very poor quality A3 images.
The image get worse on multiple copy runs. The image is perfect on A4 and the gradation...
Thanks for the suggestions, I have already said a replacemnet copier is the best fix and the customer is happy with this, as am I.
Tried this, no change just the lower case d, I am seeing this d when i close my eyes to sleep its haunting me.
The panel won't respond so can't get in to service mode. I have told the customer its not worth the effort, but i would like to fix it, proffesional pride and all that!
Offered to look at one of our customers old machines a Sharp AL1456 it has a lower case d in the display and won't do anything. I have looked through all our sharp literature and can't find any...
we have had this a few times it will be the copy button remaining on there is a modded button which stops this.
Thank you that sorted it.
Pretty new to kyocera stuff so have very little to draw on. The machine puts a message on the screen "cannot use this function" when you select tray A, which is the main tray on the finisher or if...
We have had a fuser lamp blow in a C352. The fuser is virtually new and we suspect the lamp blew as a result of a bumpy and difficult install. Does any one Know where i can get a lamp (the double...
Thanks for the replies. feel a bit of a div fault was a cracked loom which had blown a fuse on the power board.
I have a C250 bizhub which won't recognise it has an adf fitted. When you check the firmware it shows no adf firmware installed. I have flashed the machine firmware and tried a different adf with...
I can't believe how well this works. Thank you for your prompt response. I hope i can return the favour at some point.
What does TK1 refer too. I have got the simulation codes for this machine but have no idea what this refers too. The machine has been taken in by one of our existing customers as part of a payment...