Search:

Firefox.

Anyone else get an email this morning?

Dear WWW,

Someone has tried to log into your account on Copytechnet.com with an incorrect password at least 5 times. This person has been prevented from...

Great minds think alike! You must type faster than me though, because your post wasn't there when I started replying.

Wait a sec... you say you changed the blade and drum. What about the charge roller?

OK, I'll take a stab at this. Wrong firmware, perhaps? If it has firmware for a different finisher, this would cause issues. Also, corrupt firmware.

What other accessories are on the machine? ...

Ooops, I misspoke. :o Not a BRILLO pad, a scotchbrite pad is what I used. You can see it in the picture.

As for the rubbing alcohol, haven't noticed a difference between that and water, and if...

As long as the lubricant bar and the drum are in good shape, I've never had an issue.

23708

Picture shows one almost finished.

I use a brillo pad moistened on one corner with rubbing alcohol, and then wipe away the dirt with a clean cloth, turn the roller a bit and repeat.

Yes to the dirty charge roller. But why?

What I have found to usually be the cause is in the waste coil section of the pcu. Well, it's not really a coil, more like a bar with mylars attached to...

This will work as long as telnet is not turned off, which some IT departments want turned off for security purposes.

Is the sound turned on for the operation panel input? If it isn't, try turning it on to help diagnose if it is a faulty button.

As mentioned above, if the plastic rib in the lower fusing frame has broken off, this allows the fuser roller to shift in the frame which causes problems ranging from incomplete fusing of the image...