Yup, it's either FTP or e-mail.
Type: Posts; User: Kyo fan
Yup, it's either FTP or e-mail.
Finally managed to find the cause yesterday. After yet another careful tear down and inspecting every single wire for possible pinch or short, i slapped myself for making a rookie mistake. You see...
So, I was working on ECOSYS P3055dn where i replaced clutches to resolve paper jams. I replaced those countless times, and never had this happen on any Kyocera device. After putting everything back...
@mincopier
Thanks for this app, it works like a charm, even though it's from 2007 and made for windows Vista. The path is just "/" in Command center if you want scans to go to the folder you've...
Open front door and than give it a try.
Hire a Kyocera tech.
You should do U021 to reset previous settings. Print the event log with U000 first, since it will wipe it. You can move the fax card, but you also need to move the fax memory from main pwb, since it...
I would clean the lasers 1st, and check the contacts drums and devs are making on the back side once pushed in.
That code is common for this series. One of the shafts on the plastic housing breaks:
41634
There are 2 gears on these shafts that spin with transfer release motor. When it breaks, you get...
Post the event log if you can.
Replace the developer clutch.
41397
For that you need to check "Set up IP filters" when installing embedded terminals with remote setup, and that saves a lot of time.
The other way is to manually set IP filters thru Command Center for...
Did that tech do all the adjustments from maintenance after replacing those parts?
When entering maintenace mode, open front or right door and try again. On this model, i would also inspect power source pwb for blown caps since it's not uncommon, and i've had F245 before due to it.
Push the pin of the Cyan DV unit in. If it doesn't help, it could be broken on the inside, in which case you need another DV.
It's fairly common for that gear to break. Replace it. There's a bulletin on it, and It has been reinforced with shape change.
Make sure the optical section is clean.
Never tried swapping drive units between color and b/w machines. These drive units last a lifetime, except for the clutches that rust over time (CLUTCH 50 Z35R), which causes paper jams. To me, it's...
If replacing drum unit C and charger didn't help, the next thing is high voltage pwb. Re seat connectors on it, check contacts, and replace it if nothing changes.
I'm interested in values entered for mag roller voltages and thickness in U464.
That's most likely failing lift motor (the big and expensive stepper motor). These side decks had so many changes and fixes, it's mind boggling. Scroll thru service bulletins if you have access. You...
Yes, those are pre-printed and just need to be pulled after an invoice, and yes, this is one time job. So far, I managed to get it to pull from side deck and exit the same tray with this:
!R! ...
Bumping this thread for a similar problem. Got a TASKalfa 6501 with finisher and side deck. It does up to 60k invoices at once monthly from a specific software. For this month, for every invoice,...
Before changing boards, try U021 and U002. After that, upgrade firmware to the latest.