Search:

What I was looking for was just a little feedback from other techs who may have thought of some helpful feature or function that I have not. A little about me and the software... I am not from India...

Thanks for the questions. This is platform independent and currently going through debugging along with adding a few more features.

What I am looking for is input on what is beneficial for...

I am working on developing Service Software and would like to get some input on what would be helpful to have in it. Once the software is complete I will be looking for some companies to beta test...

I have a Kip 5000 with Kip 2100 color scanner. This is an 9-d a minute engineering plotter. This is our showroom model so the meter is low. $32,000 new we are selling for $9000. if interested send...

Looking for a technician to service Sharp MX-M1100 and MX-3501n. These machines are located in Roselle, IL Contact me if you are interested in doing some side work.

The fusser is not heating up. This error pops up about 15 seconds after power on and then it will shut itself off.

I am in need of help on this. I have a canon Imagepress with the error E000001-0070-05 and have not had any luck resolving the issue. Any suggestions are appreciated.

I have a toshiba e1351 and the fuser motor has a broken gear in the gear box. I orderd a new one but what they sent does not match what is in my copier. Can anyone help me out with a part number or...

I have been hired on as a service manager and my first task is to put in place a policy and procedure manual for doing service calls and all aspects ofthe service department. I am wanting to get...

I am currently looking for a position as a wide format service technician or Service Manager. I have 12 years experience in the industry and have been trained on Kip, Seiko, Hp and Ricoh analog...

I have a broken bag error and have performed the following:
1. Replaced Ink Cartridge
2. Replaced Tube assy
3. Replaced gamut pci card.
I have performed 10.1 and 11 in service mode many times...

Remove the screw off the top of the bottle and the top can be screwed off.

Do you service the Seiko plotters or inkjet printers? I have a service forum for the Seiko LP1020 plotters www.bluelink.us

I checked with my sales rep from Seiko and they have a 90 day warranty on the equipment after install. If you need a source for ordering the board or any questions about the install let me know....

Their are 2 common causes of boards going bad early. The first being caused from a electrical surge. I alwayse supply line conditioners to my customers for this reason. Cost for this is around...

The only solution to this error is replacing or repairing (if its possible) the board. Just remember when the board is replaced you must remove the NVRAM chip from the original board to put on the...

According to the service manual the reset will reset the meter count for the number of prints made. Let me know what the solution ends up being. Good luck

This site has a detailed trouble shooting procedure. Good Luck. E ENGINE 20CA

I am a dealer and have been trained on almost every wideformat machine.

black prints are caused by the main charge corona shorting out. The main charge assy. should be cleaned and the corona wire replaced. The "grubby" print could be from the developer being bad. If you...