Search:

We can supply the latest firmware for this device.

Feel free to contact us via either website below should you still require it.

Are you using the correct system software, is your device the 3rd generation or the previous version ?

Try updating the firmware (via SD card) if this works then most likely the controller board is OK. It the device throws the SC672 then you'll need to replace the controller board.
Also worth...

No, most parts are not interchangeable with the C305.

The MP C307 & 407 are basically the same machine, only difference is the speed.

Not a bad model. PCDU don't always reach life & had a few with the transfer waste backing up.

As always keep the...

We run into this issue from time to time.

A few weeks ago at a large college I was running round updating a load of iseries & the odd one or two wouldn't update using the same firmware / stick...

Take the paper out of the LCT, go to the copy screen, does the LCT still show it has paper loaded ?

The LF is just a guide. We don't often see these C-EXV 55 drums go much over 100% without causing a print quality issue. (usually faint prints)

Looking at your tiny picture it appears the transfer belt or imaging unit is not being cleaned, this could be the reason.

Yes, from the IR C3125i parts manual they are the same.

62294

Are you using genuine Konica Minolta toner & developer ?

It is usually ok to update to a latest version 'jumping' multiple older previous versions, the C759 is a sold model.

We do occasionally see issues doing this on the 4e series.

In future if...

We can supply you with the latest firmware for the Kyocera M3550idn

We can be contacted via either website below.

62228

We can supply the service manual & firmware if required.

Please contact us via either website below.

Most likely this will be the last update for a while for the old 4e series.

62225

Thanks slim, yes we can supply the latest firmware for your MP C3002. You'll just need to copy the fw to an SD card (USB not supported on this model)

If possible have both devices on the network, open up both device webpages then copy / paste the entries from the Lexmark to the Tosh.

Sounds like you need to replace the black imaging unit. However I wouldn't waste money on this old machine.

Does the C368 literally restart while a job is running so when it powers back on it has a jam etc ?

We can supply you with the service manual & firmware for any Konica Minolta device should you need it.

We can be contacted via either website below.

Had this once before.

Take out all the toners & IU's close the front cover then fit back each unit in the order displayed on the screen, this did the trick for us.

Have you compared the two? They are totally different.

We can supply you with the firmware & tool and can be contacted via either website below.

The black imaging unit is always being driven & has a charge even if only doing single colour. So if the drum is worn you will get black marks / lines.

Those lines are caused by the transfer unit cleaning blade not cleaning the belt fully after the device has run a calibration.

You say you swapped this unit with another one but I assume with a...