Search:

Hello everyone,

I have another issue with an RC6300- the master loading unit continuously runs. It will load the master and cut it. If I don't remove the cut piece it will continue to run, if I...

THANK YOU! That was the problem - set screw was missing.

Thanks for the idea!:D I'm going to try that this week. Would the exit rollers function at all at other times in the process if this was the case?

Hello,
I'm working on an old RC6300 - it was working well and kept in nice running order (Cleaned, new pressure roller, tires, separator,etc.). It started printed only 1/2 at a time before showing...

Hey everyone,
getting a bit desperate now. I need the risograph to function correctly for a workshop in a week. It still only prints one at a time.

Any help would be just incredible! Also, if...

I have the same problem - have you tried a different drum? I can reset it on the machine and its fine but if I try to use that same drum, creating a new master, it will show the T3 error. I can then...

Thanks for your reply!

I've been checking ebay and ave found some ink, rarely do I run into anything special though. There is one ebay vendor that has a good variety of colors, even yellow which I...

So for a quick update - I replaced the badly worn stripper pad, seems to be feeding the paper much more consistently, however, the phantom paper jam still occurs. The paper will come out and the...

If you can't locate it on the Riso site, I have a copy - pm and I'll send it to you.

This is so off topic. YOU were the provocateur. I normally don't engage in this type of nonsense but in this case I think its important to bring your demeanor to the addition of the readers of this...

The fins are still pretty long, they look as they they don't have any wear at all - do these parts expire with age? (Even with no visible wear?). Like I mentioned, I ordered the separation pad, the...

Thanks for the reply! The tires look great, soft and grippy. The stripper pad is bad, I ordered some and will report back on how it went. If that doesn't work I'll go tires.

Perhaps a list will be easier for you to digest?

1. You have not read any of the posts that I have made based on your response above.
2. I tried tons of keywords, any distributors that showed did...

Why do there have to be bears? :confused: My approach was completely harmless - I simply started a thread for a previously unsupported topic.

If anything, I deserve an apology as his initial...

I don't have anything to say about the administration, only that my posts were not appearing? I haven't used any derogatory language in any of my posts (Only inappropriate forum language used were...

I can list the various suppliers I've tried outside of the sponsors of this site but that would be "breaking the rules", I'll go as far to say that major suppliers do not offer any ink alternatives...

testing post, my last reply didn't show.

Every time I post a response with a list of research etc. it has to be "approved" and hasn't. I've done a ton of research, checked every sponsor on this...

Keywords I've used:
-ink
-ink suppliers
-aftermarket ink
-buying ink
-fluorescent

I've tried:
inkfarm.com (Completely off)

I've searched the forum for ink suppliers and there isn't to much info... :rolleyes:

A forum is a resource, a digital community, built to support and further develop a specific topic. ...

I've searched the forum for ink suppliers and there isn't to much info. I was hoping we could put together a list of places that offer custom inks or non-standard inks (Neons, etc.).

I use...

Also, the paper floats out as if the machine has anticipated the jam

Hello everyone,

This is my first post and I'm really glad I found an awesome resource for these machines.

I recently bought a RC6300, I know super old, but its in great condition with just...