Working on a MX-B455W and an E7-11 popped up told customer to turn off and turn on and this had cleared the issue, but recently now it wont clear. The scanner moves freely and lamps still light up...
Type: Posts; User: poekeypop
Working on a MX-B455W and an E7-11 popped up told customer to turn off and turn on and this had cleared the issue, but recently now it wont clear. The scanner moves freely and lamps still light up...
Ive got a 753 not fusing on top n bottom of paper (8 1/2 x 11). Basically front n rear of fuser. Have replaced lfr,bearings, webs. Does not appear to be anything bent or otherwise out of sorts. Temps...
Well got it set for tues. I'm thinking sensors too. Have had this b4 with other machines and locations. Just checking if other techs have seen this b4. Would not do it every time(erratic sensor). I...
363 df jamming 2nd side
I got a 363 in a prison. jamming in df when doing 2 to 2, jams show at sppd5. Replaced rollers a few weeks ago, pulled a few staples out from under white platen cover. they called back. lol. they...
363/453/503 sensor dead
ive got a couple of these, mainly tray sensors,clud, dlud, also ppd2. tray sensors show no paper in tray, motor dont lift. swap motors out all ok. what kills them. ppd2 is reflection sensor, have...
sharp arm 355 l3 00
I am having trouble clearing/fixing an ARM455 Copier with a l3-00 code. I have replaced the home position sensor. Lubed and cleaned the scanner rails. Reconnected the scanner pwb. The code clears but...
I did just change rollers,btw......I will check that out for sure. I no most little secrets on sharps. Ugh foiled again. Thanx!
3500c weird df problems
3500c, press copy with nuthing in df, trys to feed(df) shows jam. turn off(wont clear otherwise) on, samething. I ck threw ALL sensors. no clue. if you place an orig on glass it trys to use df...
The copy runs threw fine,exits out to finisher, original passes threw doc feeder,then shows jam. I am gonna tear into to see if any flags hung up,lazy,sticky. I checked with flash lite, ran...
3500c df problem
posted this a few weeks ago, more info. place orig in df, press copy, runs through fine,but shows jam in df. will not clear unless u turn off/on machine. 03 7,8 a-h e-g all ck ok until u open cover,...
i have a 3140, new last fall, web doesnt seem 2 b advancing, had the whole fuser replaced by sharp in nov. customer called back other day, solinoid activates,cam roller, levers free,springs ok...
replace liu pwb, had that a few times, make sure machine hooked to surge box.
try fuser pawls, adj fuser entrance plate. had similar problem b4, drove me nuts....
squeak ir 2200
boss picked this 1 up, "suuuuuure, we can service it" ir 2200 when copying or printing has a little chirp at the end, paper comes out,sorter resets, chirp! almost sounds like a motor when it stops 2...
thx, will give it a shot next time at cornell, suprized their "it" guy didnt find this...lol..."they checked, said it was our machine"
machine shows jam after running, none found, will not reset unless u shut power off/on, can run again, then shows jam,again. i was told maybe power problem? part of a package i service.
customer called says machine keeps "rebooting", went to service, runs fine without patch cord, as soon as u hook back up,keeps shutting down. anyone ever seen this? i checked all the obvious...