check developer mag roller grounding plate if it touches mag roller shaft (front side)
Type: Posts; User: makaule
check developer mag roller grounding plate if it touches mag roller shaft (front side)
Have 2 pcs of E-studio 550. One of them prints PDF quickly and another is very slow. GL-1020 Configuration Page shows different print driver versions on them. Print Emulation on quick one is...
I can't say that it's damaged, only when I clean it it looks more shiny. The same problem is with cyan developer unit. Swapped them with one's from another working toshiba and now everything is ok...
https://profiles.google.com/mckaule#mckaule/about
Phone made photo of dev unit..
gap is 0.45 - 0.5. More ideas ?
Color developer unit problem. Toner and developer adheres to the rear side of mag roller making ~1 cm round bump which contacts with drum and starts making color banding on copies. Any ideas ?
...
Yes.
Changed all parts, all developers, tr belt, all blades, cleaned laser unit, 1-st and 2-nd CR/Tr rollers, fuser kit and etc.. Reset all counters. Cleaned all sensors. Made auto gamma correction,...
Swaped CRG corona with one from old studio 45. Working perfect.. :) Thanks..
Error code C970. Cleaned all coronas, but time after time code appears again. ? Any ideas ?
Wire is broken somewhere under the shell. I can't see where it is broken..
Need only P/N.
Forgot to plug connector to sensor after cleaning and changing developer and it seems that I managed to brake the wire when pushing dev unit into copier. "Insert Developer Unit" is on display. :(
Can anyone write P/N of harness which connects to Auto Toner sensor in dev unit ?
Thanks.
Problem was in PLG board. After changing PLG also had to change one more TR belt mot board. :-/ Now working more than week with no jam.
Developer is disapearing by little and after about 50K copies I had to refill it. Checked and cleaned all contacts, main charger, checked all gears,reset all counters, etc.. Drum is brand new. More...
Changed LGC board, TR belt motor and controller. Checked all sensors. But nothing helped :(:(:(
code E-01. Like I said, paper stops on TR belt after passing reg roller. Cleaned all sensors, you can turn TR belt with "one finger", there's no exessive load. Motor is turning reverse before copying...
Paper passes reg roller fully and jams between drum and reg roller, not reaching drum scrappers. It seemed like tr belt stop turning for a moment, but in 03 mode all motors worked fine. Changed tr...
Works as clock after changing lower clutch (6LA66937000)
Thanks for your advices. I'll try doing what Toshibatech said, couse it's the same when doing from LCF, not only from lower drawer. Let you know..
When copying from upper drawer everything is fine, but if copying from lower drawer a wave on paper and white vertical line appears on text. Clutch ? Which one ?
Changed drum,TR Belt, all Devs, all blades and brushes, also all FUSER KIT but now after about 5K prints/copies thin black horizontal lines appeared. Changed all cleaning blades and even DRUM but...
had the same problem with my studio 650, getting errors C46, C47, C48 for several times every day. It was like splinter in my ass. Changed main door switch and now no more codes for more than 2...
Jamesyboy, you were wright, cleaned all rollers and nushings transfer belt unit and now copy is solid. But moire effect is still very intense :/ Any ideas about that ?
i'll try and let you know..