Salesman picked up A service account of a real estate company. All had gone well until machine decided to stop scanning to e-mail one afternoon late.
It initially was having authenticating issues...
Type: Posts; User: tr21x
Salesman picked up A service account of a real estate company. All had gone well until machine decided to stop scanning to e-mail one afternoon late.
It initially was having authenticating issues...
Sorry,
it worked in the situation I had. I have one other idea are the end blocks of either the charge or seperation caronas cracked or damaged. Try cleaning those with some alcohol or laquer...
Check the Drum Pick off finger Solenoid. I had the same issue on a 2400wd.I changed out everything you changed out and found that the solenoid was misfireing and or sticking open.
Had the same problem with a Savin 8075 last week changed Lased Diode and fixed problem have not herd a peep since.
Yes, they have a filter I appriciate the help you have submitted. I will try this tomorrow and update this weekend.
Does anyone have a workaround to make this old relic a viable fax machine using VoIP. Have tried lowering baud rate but to no avail also made sure the line was set to analog. Tech support said it was...
Here ya go.
Someone has been leaning on the left front corner of the machine. Lift the left front corner up till the copy clears up. It may take a couple of times to get it back to close to normal.
Your waste toner bottle is full
It could be a million things but a few simple things are as follows
Is the post script option installed on the machine.
Is the machine DHCP or Static.
What does a ping command to the device come...
Look for the best service department.
you will be owning this machine for a little while so you won't see the sales people however you will see the service folks. Ask for avarage call response time...
2 ways to get into service modes
Turn machine on holding down the online key and escape key till the display changes
or
hold down the up and down keys together for about 5 seconds then press the...
Replace pressure roller
Check the little drum ground on the bottom right back side of the drum case.
If you happen to be a dual dealer with canon or know a canon tech you can use their old hard drives after they crash with their software on them.
I have used several and all have worked flawlessly...
No checked all in sp modes and all are in spec range
I have A Lanier LD122 that has an issue of the dev sticking to the drum. I have upgraded the firmware, also initialized the dev after replaceing the the drum letting the machine do it's...
user tools
fax features
program fax info
highlight and change name
It also can be the pcu had a simiular situation replaced the pcu and squeek has not been heard from again
I have the same part # as of today it is a good #
SWAP OUT BCU
Push the following keys in this order in less than 5 seconds Clear modes button(yellow button)then 107 then press clear stop key(orange-red) key hold it down to get into service modes and then...
You have a screw at the top of the plate and a krob that that is big around as a golf ball that truns clockwise and unscrews then the plate will come off. If you can't get it to break loose flip down...
HAD THE KINDA SAME PROBLEM AND IT WAS THE WIRING HARNESS IN THE PAPER TRAY
Make sure carona power pack is plugged in and that the carona wires and carona grid are clean with no carbon build up on either.
Hand clean the wires and grid don't let the machine do it it will...