I'm experiencing a similar issue. This unit is a 8353ci experiencing color background magenta for sure and i feel like i see some yellow also.
I have also replaced everything above. even swapped...
Type: Posts; User: Rpizzle
I'm experiencing a similar issue. This unit is a 8353ci experiencing color background magenta for sure and i feel like i see some yellow also.
I have also replaced everything above. even swapped...
How about checking if the paper stack limit plastic piece is still on the exit flag?
I have not seen this on any of these units, with such a low count I have a hard time believing there is...
I have seen this to many times with this Kyo belt. different things see to fix it. I would start by stretching the cushion connector of the machine out ever so slightly, then re install your belt and...
Looking for a good source for Toshiba parts. Thanks In advance! ;)
That actually is close to me. What is the name of the distro?
oh man! After this passes do you think I can buy toner from you?
Just a thought. How are these connected. I remember the 2640 had a fw for usb connection not waking up. Sounds similar.
Hoping to get linked up with a sharp connection.
Preferably a dealer.
MX-B70T for our Sharp MX-B707P printers
I am in desperate need of a firmware/service tool. Had a drive go out little did I know this was going to be this annoying..
How do you print off the test charts on toshiba? kyo tech. I'm having to work on a toshiba estudio e6506ac.
Precision roller seems to be reasonable + free shipping. From Kyocera you will have to pay for shipping plus you're not buying direct. Lucky to have them in stock over there I would buy them now if...
I hope you have gotten to the bottom this I didn’t see that you have resolved this but I will tell you a personal experience I had recently. Went out for a paper jam just like this and was expecting...
sounds right. sent you a pm.
Does anyone know the purpose for this updated drum unit DK-3192(BOD). Having trouble finding it on Kyoceras end...
thanks
Without pulling a diag, would say go in form the front remove bridge assy toner slots not much room in there.. if you have ever had a 4551ci out its very similar
I usually just use Admin Admin. I get mixed up on the numbers frequently.
Not much to go on but could be polygon mirrors possibly. May just be staring to be dirty. This model is prone to this type of thing the rear edge will start to get light. not necessarily on every...
I would have to agree with fish up there, used to have 3050cis do this all the time.
looking for a canon ir advanced 6255 drum anyone have one laying around? thanks
You can bypass the fax problem by unplugging the fuser typically. Then go into service mode and 671.
yeah I read through this thread looks like you have been chasing this around! Hoping that laser takes care of it for you. IÂ’ll be checking back
I have a 7003i doing this with 3k prints on it. I had the tech check the clip and it was on my unit. Tech informed me the belt did seem a bit off on that side. We’re going to change it out and see...
302NJ94070 _ PARTS PWB FRONT MONO ASSY SP.
any progress?
I've had reg roller fix skew like this. also will add when my problem first occurred it was only from tray 3 then eventually spread to all the other trays down the road.