Just put it in silent mode under maintenance and adjustments in system settings.
Type: Posts; User: Paulm
Just put it in silent mode under maintenance and adjustments in system settings.
Thanks for the responses. The unit I'm working on is newer than the tech bulletin cut off. I pulled the unit and lubed everything. all gears rollers and follower rollers. Issue resolved. I do think...
Hi all, getting a clicking noise coming from the exit section and wondering if there is anything specific I should be looking for or if anyone has remedied this issue before. That lower exit section...
Got it off, Thanks again.
Hi Thanks for the response. I have to replace the laser unit. Funny my manual absolutely doesn't show that scanner removal procedure. Where are those 2 retaining screws. I figured it had to slide off...
Anyone know how to get the scanner off of the ecosys m3550idn? The manual doesn't show and I just can't seem to see how. The manual only shows how to get covers off after the scanner is removed....
These machines have a history of bad SD cards that have that exact symptom.
Hi All,
Hoping someone knows the answer to these 2 questions being posed by a customer for our current Sharp systems.
Do they have;
1. Capability to print and send outbound faxes from the...
Data Security kit. When you install on one of these units before you install the firmware it will only boot to the cn screen. That's why I was wondering. Does it boot to the CN screen with the...
Where did you get these MFP-SCN boards? Could possibly have gotten one with a DSK installed? Just a thought.
If you can catch it the job status while it's printing it may give you the computer or user name sending the print job. Had to do this many times. Had a corrupt rogue print job one time that kept...
Since they are just copying them have them put them in upside down so the staple deformed corner is at the bottom right. That may fix the issue if it's the deformity causing the it.
Hi All,
Hoping someone can help me with this as Sharp tech support is down because of the storm. I have a new MXM3570 I'm setting up and testing in shop. It has a fax installed. When I hit the Easy...
If the other solution doesn't help. When in training we were told by instructor that when you get a lot of cleaning transfer belt messages (crazy as it sounds) is caused by roller timing. Mostly...
I concur. mSATA. I've had 2 go bad on relatively new machines.
Try SD card. Classic symptom.
4111 has it 4110 doesn't.
Instead of SD they have mSATA drive. Had to replace 2 so far on these units. If you have a spare unit try it first. Then clone with HDD Raw Copy and re-image the original mSATA from the unit.
Hi
Have run Sims 61-13 & 61-11? Might help. I would also run all adjustments in SM that pertain to density. Also, you are in Florida, Humidity plays a big part in copy quality, Bring fresh paper...
Hi, Does anyone have a clean SD card image made with Raw Copy for an MX-5111/5110n they could send me? Before you ask, I was given the green light to burn SD cards by an instructor. Much appreciation...
Hi Setting up a MX-6580 with fiery. Followed all setup instruct but when Click on Fiery icon on screen get CE-00. Anyone have a
clue? Thx Paul.
Probably MCU PWB is bad. I have one those machines sitting in my boneyard with that exact problem. As suggested test the solenoid and then switch connectors with tray two. If solenoid fires, board is...
What parameters are you using to set up the printers on the macs? Are you using IP with LPD?
Wanted to follow up incase anyone has this issue. I know it's been a long time since this thread started, just came across it when perusing the forums for something else. Anyway, issue turned out to...
Just wanted to update this with the solution. Sharp furnished me with original activation key so quickly that I get the impression this is a known issue. All's well that ends well.