Looking for somebody to work on 2 Xerox Nuvera 120 machine in southern central Michigan.
Type: Posts; User: tpant
Looking for somebody to work on 2 Xerox Nuvera 120 machine in southern central Michigan.
I can connect from Windows version of FreeFlow Remote Print Server and everything works fine. If I download driver for DC700 and FreeFlow from Xerox the client can't see or connect to printer.
...
Is it possible to print to a freeflow print server from a regular mac or windows print driver.
Thanks
Tom
I can see the FreeFlow server from a web browser by entering the IP address. The Xerox Print Driver downloaded from Xerox will not see the printer even when entering the ip address.
Thanks
Tom
Just got a Xerox 700 and it seems to be using a lot more toner for the same jobs as our Xerox C70. Any suggestions?
Is there a way to do a COPIER > FUNCTION > PART-CHK for the ATR patch sensor shutter motor. I don't seen anything listed in the attached table of motors under PART-CHK.
Thanks
Tom
How can I activate the patch sensor shutter from the service mode?
I am buying a C8000 that has had the hard drives wiped. Trying to figure out what I need to reinstall the system.
Thanks
Tom
419-215-8434
This is the error from the manual:
0x91 Lower limit error in ATR patch image density
DISPLAY>DENS>DENS-S-Y/M/C/K (patch reading
value after calculation) >/= 880 when making prints
1....
I am looking for the system disks to do a fresh install for a A1100 & A3100 Fiery server.
Thanks
Tom
The only cables going to finisher is a 4 or 5 pin power looking cable and a db9 cable. Should there be a ethernet cable going to finisher.
The "mimic" in top right corner only shows feeder and print engine.
Just setting up a new to me Nuvera 120. It it not seeing the finisher. Any suggestions are welcome.
Thanks
Tom
I just purchased a Nuvera 120 and trying to get it going. Boot up and says license has expired. I really don't know were to start.
Did you ever get this figured out. I am trying to get a Nuvera 120 running. Says licensee has expired.
Does a corona wire ever really go bad. If so what would be the effects of a bad wire.
It now seems that I have not been oiling the fixing belt assembly properly. I cleaned and oiled again. So far it is working. Any tips on oiling fixing belt the isn't in the manual.
Still having problem. Same thing E014-0100 and also jam code 0CF1. Pulling my hair out.
Ended up being 2 things. The flag that controls external heater position was broken. Also gear that drove fixing belt had a crack in it causing drag. Thanks for the help. I hope this helps...
I restored defaults. Ran full graduation and calibration. Still same results.
You mean just restore defaults in the CWS calibrations?
That is exactly the process I use for calibrating the printer. I still ended up with the calibration curve in the photo. I was wondering if there was some hardware defect that would cause this...
What would cause a calibration curve like below.
27781
I found it. I had TNR-DOWN set to 1, changed to 0 and power cycle, auto graduation, calibration. Level are now low, but within the .15 to be in spec. Thanks.
I have changed DMX-OF-C to 1 then 2 then 3. Power cycled then did Full Auto Graduation and then calibration. I have no change in the calibration curve.