That is HDD code, replace HDD
Type: Posts; User: tykesupport
That is HDD code, replace HDD
System Software Package v16.05.01
Use the Following Steps to change the Default Copy settings:
1) Press (Main Menu) button.
2) Use the (Scroll Wheel) to select <Copy>, then press [OK].
3) Change the Copy Settings to what...
Are you sure that you have those options installed, check the device configuration in the counter check. You may also want to check if the send is disabled in service mode.
Light Density Image Fault Due to a Defective Developing High Voltage Contact
TP12 282.pdf,
This Technical Publication describes the permanent countermeasure against a Light Density image fault...
To clear error codes (E000, E001, E002, E003, E717, E719), COPIER > FUNCTION > CLEAR > ERR, 1) Select the item, and then press OK key.
2) Turn OFF/ON the main power switch.
Check OPC drum of specific color creating error code. Inspect the drum flange and check that it is not loose on the ends of the cylinder. When loose the drum slips on the drum shaft when it...
The part number for the imagePASS System Software CD Version 1.0 is FE1-6180-000.
Hello, are you refering to TP10 148.pdf, Action to be taken if a pickup Jam 0003 or Double Feed Occurs.
Please send me an email and i will send you the PDF format.
Hello are you still looking
Hi RHodg57, what is your email address?
Check the right inner door assembly FM3-5960-000, you may need to replace it.
[/QUOTE]
Check Your Email
Need Help ASAP please, I have a CS3010i with a feeder and the customer is scanning color documents to file and the colors are incorrect only when using the feeder, Glass works fine.
Hi Will1, Did you home out all the laser in service mode ? copier>function>laser (level2)
1)Input the white level data (barcode value in the copyboard glass right upper) of the
standard white plate.
Lv. COPIER > ADJUST > CCD >
1 W-PLT-X W-PLT-Y W-PLT-Z
* 820686679349 *
Label
W-PLT-X...
This error code refers to the additional finisher tray. Check FU3 on the upper left corner of the finisher controller. If it checks out good, power the machine off and lower the finisher delivery...
Hi Copymech, Sorry for being a pain you know what, but what is the purpose of the test chart if you do not scan the chart through the feeder, and do you enter the values of the copies or the...
Hi copymech, tried all the adjustments in service mode and i can't get the feeder to scan the correct color, do you know which service mode i have to run with the chart?
To format and flash the machine you Service Support Tool, SST. You can go into service mode *28* COPIER>FUNCTION>SYSTEM>CHK-TYPE and clear HDD partitions.
Remove network cable and reboot the machine, Try another driver or crossover cable with a laptop. May need to flash the machine.
Open the door and check the display panel for re-seat unit 1 message , check for paper at the rear of unit 1.
Hi Hong1007, You can only get that at the techsupport download Website.
Please help, When scanning color to file with feeder, the color is off. Scanning on the glass will pickup the correct color. Is there an adjustment that you have to do at install?
The most common causes are door and lower right door related. There is a remote signal that runs through the HVT that shuts off power to the HVT if the door is opened, if the signal is lost during...