I know this is an old thread but I have a machine with the exact same problem, was working fine last week turned it on today and it doesn't work. I can also hold down the utility button while...
Type: Posts; User: rofield67
I know this is an old thread but I have a machine with the exact same problem, was working fine last week turned it on today and it doesn't work. I can also hold down the utility button while...
lets try this attachment again.
I am still fighting this problem on a few machines, all black issues, open and close process unit problem gone for a while. I thought it was a round issue because when I tested the drum drive shaft...
I had the same problem, mylar on the fuser exit plate kept getting damaged, I peeled the thin mylar off the plate and it worked great. Hope this helps.
Its back, as soon as you open and close process unit problem goes away for a while. Any input on this problem would be greatly appreciated. Thanks!
I am looking for a working IC-408
I think I have solved this problem, I found cyan developer leaking from rear side getting on HVT connectors on real wall. I removed process unit from machine and vacuumed and cleaned all connectors...
I am having same problem with a C6000, driving me nuts! as soon as you open and close process unit it disappears for about 400 prints, then its back, I tried everything including HVT2. Maybe I will...
Check the process unit connector for damage, it is located on the back of the process unit and also on the back wall of machine. You can try cleaning them with contact cleaner. Good luck.
Just ran into this problem on c6000, turned out to be worn fuser exit plate.
replaced with new and also swapped with other colors, no change. Maybe arching connector on machine frame or bad HVT, HVT and connectors very difficult to access on this model, my have to try it...
Intermittent Black banding with dark 1 inch darker band on trailing edge. Banding shows on black half tones and darker band will show on non image area even on color monochrome test pages. If I open...
always OEM. I thought it was a coincidence but I found problem on several machines only with the toner with skew # I listed. Just a heads up to save you some time troubleshooting if you see this...
My bad, machine I am talking about is C6500, TN610k.
I have found some bad black toner TN610K for the koinica Minolta c6500. I have been fighting a problem with spoty half tones, black only on a few of the machines I service. . I did a developer change...