Have them call their hp tech. Use to have this problem all the time at a college originals come off the printers not fused all the way.
Type: Posts; User: Dean
Have them call their hp tech. Use to have this problem all the time at a college originals come off the printers not fused all the way.
how do you reset 009-356code on this copier. Iknow it is caused by the toner cart. not being shaken long enough. Thanks
Dean
Does anyone have a pdf version of the network admin guide they could share?
Thanks
Dean
I am getting very pale copies and having problems running the calibration.
I have tried loading 11x17 in all three cassettes but when I press execute the machine runs for a few seconds then it says...
I already checked that. Thanks though.
I had to take the fax board off a machine in the office and put it on a customers, when I press the image send button it says to turn on the fax switch but I cant find one. I have looked through the...
If admin / Sharp does not work reset the nic and try again after you reenter the IP number.
Copier jams at reg roller every time when the finisher is plugged in. I know that I need to replace the small board that piggy-backs the main board.
Does anyone have that part number?
Thanks...
The last time we bought the scan software it was $700 but I think that it has went down to $350.
Dean
Try sharp.ca it has more manuals than the us version.
I am trying to set up the print on the Imagepass c2. When I go into the setup it asks for a password. Is there a default password for this unit? or is there a way to reset the imagepass?
Thanks
...
I need to set up the scan on this model but I have not had time to play around wit the machine. I have set up scan on Sharps & Kyocera Mitas.
I need any advice and drivers that anyone can...
I put the print board & NIC out of an old e55 we had in the shop into one of our customers machines. As far as I know they were both good. Now when you press print on the control panel it displays...
Thanks for the help.
Has anyone upgraded the memory on this model. I know it can have up to 320M in it, but what type? And do I have to do anything in service mode afterwards?
Thanks
Dean
Has anyone had any luck printing throug the parallel or USB port on this model? When I send a print job to it it just disapears. I have tried on 2 different machines. I think I am using the right...
My tech was working on a problem on the finisher in the shop when I went back to check on him he was plugging in a connector to the finisher main board with the power turned on. Now the copier does...
Thanks I will give it a try.
Is there a reset for the finisher on this model? one of my techs was testing the stapler and got an error code. I do not know the code he did not write it down. Now it says that the finisher is out...