I agree with the HDD isolation. Also, you can get the boards refurb at Hytech. Google it for info.
Type: Posts; User: Specialist
I agree with the HDD isolation. Also, you can get the boards refurb at Hytech. Google it for info.
You might want to see if the default settings for the Doc feeder are photo/text. We have found that we have lighter images when it is set p/t rather than text.
Just a thought.
I believe there's at least 2 versions of FW that are above what you're listing that address several issues. I'd advise you to try that before going any further. Engine = 1700, Cntrl = 516-999. ...
Can't find out how to reset the fuser or laser counter on a bizhub 20P. Anyone got ideas? Is it like replacing IU (hold Go button 4 secs)?
Are any of the gates open or broken inside the finisher? What about the interlock switch: malformed?
CONT means that the TX/RX was interrupted at some point, but then it repeats the communication to fulfill the fax. This is a good thing as otherwise the fax would not be complete. With some...
If you don't turn on the switch to display jam/failure codes, these machines will show nothing. It's correct to enter service mode but don't reset the error until after you see it listed. Sometimes...
There is special firmware available for this problem....GCZ-D1
I also forgot to mention the horizontal conveyance clutches, although that usually just affects tray 1. Also, you might look at the vertical conv. clutches on the right side if it happens on tray 3...
The oneway behind the ADU carriage can be the problem (and possibly the shaft). Also, you may want to change the registration clutch and the sensor flag.
Thanks! Appreciate your help!
Looking for the correct code for formatting the HDD (08-823, other models) on a Toshiba 4520C. Thanks.
Unfortunately, we can't remove the HDD and destroy it. That would be the easy way. It has to function like factory default when we're done. I don't know how to get into service mode though, if you...
Hey thanks to all for the info. Sounds like a fairly easy job!
We recently received several Toshibas, models 2330C, 2830C,3520C, 455 & 555, that need to be returned to the leasing company. Their requirement is that we need to sanitize the machine's HDD's and...
We recently received a Canon IR-ADV C5030 to be returned to the leasing company, which requires us to sanitize the HDD and reset the machine to factory default. Can anyone tell me how to do this as...
There are 2 dipswitch settings that get changed. Sw 26:2/3=1 & Sw 28:3=0.
A couple things can cause this. It may not be related to the inversion section at all. If the timing from/before registration is off, that can cause it. Also, if you can duplex singles but not...
Unfortunately, this model doesn't allow you to perform load checks. You can only see change of states with sensors. You can run it in running mode but that doesn't isolate component areas. This is...
System 2- second page.
Another possibility is that the mirrors are not parallel when in the scan position. Look for an obstruction or warp caused by the shipping lock screws. Usually, it's the scanner bed needing to be...