Still looking for this part. I was able to fabricate a workaround with the help of a friend to keep things going until now, but it’s finally and fully given up the ghost.
Ive had some issues with...
Type: Posts; User: reignbear
Still looking for this part. I was able to fabricate a workaround with the help of a friend to keep things going until now, but it’s finally and fully given up the ghost.
Ive had some issues with...
I had a similar issue that turned out to be a ground wire that over time disconnected from one end. If you are still having the issue and have tried all else start looking for little green wires that...
looking at the tech bulletin, the old main drive gears are all 3 black plastic and the new ones are 2 smaller metal gears and one large white gear. I'd also be curious as to what the error code are,...
My RP3700 has the original elevator motor assembly without the added metal shaft for the first gear and has failed on me due to this. I'm in desperate need of a replacement, but I'm having a...
Thanks for the input. I didn't see anything in the tech manual about adjustments, but figured I could have missed something. I guess I'll go ahead and order the replacements, couldn't hurt to have...
On my rp3700 one of my transfer belts seems to be giving me some problems, it's the left middle belt (skinnier ones). Paper isn't being ejected all the way out of the machine and I found if i wiggle...
once i got the ground wire securely re-attached, the machine has been powering on fine. only issue remaining is the paper size detection sensor...for the time being i'm just manually selecting the...
Thanks for the reply, once I got the tape situation on the position-b detection plate sorted out the errors went away.
I use an older macbook pro with bootcamp and windows XP. Does your rp3700 have a network card? I have mine hooked up to the router in our studio, was a bit of a pain to get all set-up, but not too...
Sorry about that, exhausted and frustrated isn't the best condition for thorough communication. I was working on issues related to the position-b detection plate and paper size sensor among others....
After a long week of trouble shooting and reviving some drums, all was finally going well and then just as I was about to call it quits tonight my machine cut off. I hit the button to lower the paper...
I think i found the culprit and hopefully the unit doesn't need to be re-timed. The machine was previously neglected for quite a while before i got it and it was covered in all kinds of dust and...
just when i thought things were starting to run well, I was hit with this one last night. It pops up whenever I try to do basically anything, I hit reset and it goes away and then pops up again when...
as a recent purchaser of a previously neglected rp3700 and drums I can empathize and would say be prepared for lots of little things to pop-up that you'll have to deal with. getting a copy of both...
thanks for the ideas. I tried shooting it with some air and it still seems to be cutting in and out, have it on manual detect for now...
I'm having issues with my paper size detection sensor intermittently not sensing on my rp3700. leading the machine to register ledger sheets as letter. Is there anything that could be causing this...