Don't forget to clean the TD sensor as well, prior to replacing the developer. Then add the developer, then run your calibration. AS Jhonjon said, make sure it rotates - the dev/toner mix may have...
Type: Posts; User: Coolnorth
Don't forget to clean the TD sensor as well, prior to replacing the developer. Then add the developer, then run your calibration. AS Jhonjon said, make sure it rotates - the dev/toner mix may have...
It is not easy to tell by looking at the level within the developer, but, if you have a developer open to view, slowly turn the mag roller and note how well it coats. If the "brush" is thin and you...
Are the fuser pressure release arms (activated by the right door) moving properly? Sometimes these get damaged, the clear rollers fall off, they get loose enough to not align with the door...I can't...
Hi Teckat,
I wondered about that possibility as there is little else that could give the image issue in this fashion. I am surprised that a BD error wouldn't come up in this case. Looking at...
Hello all,
Looking at an iR1023 with blurring from front to rear frame side bands, irregular in width and not ever in the same spot on the page. Canon Tech Support recommended changing the IP...