OMG I think that’s it. It’s all coming back to me now. Thanks. Just another one of my senior moments.
Type: Posts; User: Brian8506
OMG I think that’s it. It’s all coming back to me now. Thanks. Just another one of my senior moments.
Should be FE8-5335-000
I found the solution to this a while back and can't remember it. When I put an original on the glass and hit start, it scans it and then gives me the option to scan more, cancel or start copying. I...
The passwords are probably administrator and 7-6-5-4-3-2-1
Sent from my iPhone using Tapatalk
You can’t turn that off.
Sent from my iPhone using Tapatalk
I believe that code would be a stationary jam in the fuser. The grease on the heat element could be dried up and cause hesitation. That takes a special grease. If you have a fuser unit to swap that...
You should check all the flag areas for old rubber dampers that can stick. Also the solenoids in the paper feed units especially on the older machines
Sent from my iPhone using Tapatalk
What’s the jam code
Sent from my iPhone using Tapatalk
What about DV unit? If the drum is generic that could be a problem too. I’m not a fan of generic in color copiers especially toner.
One bad toner and you can ruin the DV unit.
Sent from my...
I just had this happen again a couple days ago. I have found with that model if it jams and there’s paper on the transfer belt when the user slides out the transport section the paper gets pulled...
What have you done so far?
Sent from my iPhone using Tapatalk
Service mode should give you ideas on what to replace. You should also check the connectors for paper on the transport side and in the rear of the machine by the frame where the transport engages.
Make sure there’s no scrunched up paper in the drawer connectors
Sent from my iPhone using Tapatalk
It could be a number of things but start by reseating the connectors on the duplex driver pcb behind the front cover of the transport unit. Go into service mode under error and it will give you other...
It’s never been orderable. I’ve run the machine without it. Or time to upgrade.
Sent from my iPhone using Tapatalk
It is not a part you can order.
Sent from my iPhone using Tapatalk
You need the special firmware for smb 2&3
Level 1. UI-send Default is 1
Minor disassembly for a copier tech.
That machine uses 1 interlock switch for front and side doors. 1 brass leaf spring that probably needs to be reformed. You have to take that area apart to get to it.
Sent from my iPhone using...
If it’s the same as older models I believe if you go into service mode level 2(if not level 1) I think under options somewhere look for ui-send and turn it on. Memory is not what it used to be
...
There is a bunch on Ebay mostly compatible. Saw one OEM but they wanted $247
If you had the laser out and now get blank prints you might not have reconnected one of the ribbon cables properly.
Sent from my iPad using Tapatalk
I’ve had that happen and the new drum unit was defective.
Sent from my iPhone using Tapatalk
That machine probably has 1 interlock switch for the front and side doors and one of the leaf springs may need to be bent back. The old C5030s and a few other models had that.
Sent from my...