Copies come out very light except in the middle. Toner is not being supplied to the dv.Colors are good.Error codes E020-00FF One motor on the toner hopper is bad.Has anyone had problems in this area...
Type: Posts; User: kings5586
Copies come out very light except in the middle. Toner is not being supplied to the dv.Colors are good.Error codes E020-00FF One motor on the toner hopper is bad.Has anyone had problems in this area...
Can anyone tell me what a E0000990-0000 is on a ir 3380 copier.I looked at the waste toner assembly for damage.Everything looks ok.
Use earlier version sst 3.21,3.35 Use hawk cable parallel to usb Download 2-8 If copier is connected use 2200n if not 2200 Format hdd then system software,also i use part # wm2-5230-000 hdd.Stay with...
You have a bad sensor or paper stuck somewhere blocking a sensor.The only other thing is maybe a wiring or dc controller problem.Good Luck
Thanks Screwtape,I'll let you know what i find out with this e copy.
I did correct the rebooting problem.I unistalled the main controller and dc controller and reset all the connectors. i ran the copier for two hours and the copier did not turn off.The e copy is...
are you getting a 0094 jam code
Thanks for the help everybody. I'll keep working on it and let you know what fixed it. The error for the e-copy came up after i scan the document in the feeder e9001
This Canon ir 6800 keeps rebooting in the middle of a copy or print job. I did have the main controller and dc controller out because of a toner problem E-013. I was really careful when reinstalling...
Has anyone had a problem with the canon 1370 as far a wrinkling the paper.It does not do it everytime.I did replace the fuser unit and tryed fresh paper i picked up at office max.The only thing i can...
Under addition function-common settings- tray destination i can't highlight the ok key to switch s1 trays a and b Has anyone come across this? Thanks
Install sorry
Hold2-8 down at the same time and turn on main power-download mode.Use a parallel to usb cable.Format hhd Then insall system software.
Problem is fixed. Flapper for the fuser was sticking in those rubber stops on each end.It was not moving freely.Thanks for the help.
Thanks for getting back.
I am going to a 4570 canon tomorrow and this copier is jamming off and on in the fuser unit(wrinkles or creases)its been doing it for awhile.A few techs have been there and cannot seem to figure it...
I'm having a fax issue on a canon 3045 I can fax(send) out but cannot receive faxes in.The phone line is good because a stand alone fax machine works fine.Any settings i should check?
I'm leaning...
CCD took care of the problem. Thanks
CCD took care of the problem. Thanks
Replace pot.control board,harness and sensor all at the same time.They are calibrated and must be installed together.
Thanks fo the info. i"ll check it out and get back with the fix
Print jobs and test prints come out fine,but when copying or scanning copies come out washed out with random black grid lines.Replaced cable.reader controller,memory bd Cable.Thanks
Hold 1,9 key down at same time and turn main power on.It will do a scan check.blocks will drop down and it takes about 15 mins.download done.repower copier. if that does not work replace hdd in back...