It was the NIC board, removed it and the copier boots normally.
Thanks everyone.
Type: Posts; User: Taggerung08
It was the NIC board, removed it and the copier boots normally.
Thanks everyone.
If I disconnect the MFP board, would the machine be able to boot up for testing purposes?
Thanks
I believe the only fan that turns on is the HDD fan, no fuser warm-up or other fans.
I have a Sharp with a darkened screen when booted up. I can barely see the sharp logo for the loading screen and it stays stuck on that permanently. I hear the machine doing some warm-up function but...
Thanks,
Any chance you have this doc the TSP refers to? "FM1-K348-010 Replacement Procedure.pdf"
I have a Canon Imagerunner Advance C5250 with the E075-0103, (ITB traveled forward towards front of the machine).
I don't see anything broken or out of place on the ITB assy. like a broken arm or...
There's 2 of them mate
37875
37876
This was the closest answer. I tried to get it to do the Boot System Error and the Controller System Diagnosis thingy, neither of which worked.
On a hunch, I replaced the Main Controller #2 and...
I can't get into service mode. I would try it though.
Hi guys,
I got this copier second hand with the HDD removed. I put in a new HDD and formatted it successfully, after the machine restarts it gets stuck ( I left it for an hour) on the screen...
I'm new to the Xerox world, need to help a field tech with a Xerox 4112 and the manual indicates "install the Monza PWB" as one of the solutions for the 123-333 code. I don't know what a "Monza...
Scanning from a copier over a network is the bane of my existence.
Is this a new install? There is likely nothing wrong with the machine, but you will need to double and triple check the settings...
Thanks, this helps a lot!
Can you post Installation Guide? Don't have access to KMAConnnect Thanks
Hi guys,
After revisiting the site, I'm starting to think this is a mechanical issue caused by end user not installing toner properly. It usually gets much worse after they install a new toner. ...
To be more exact - the DP 760 has a "wire interface video cable" Part number 303LK46011
The DP 750 does not, and the 300ci does not have the interface on the body of the machine to accept that...
The type 1027 is compatible with the AF3350's. They are also a little cheaper and have a sturdier gears in the back of the developer in my opinion comparatively.
Hi folks
Stupid question from someone that doesn't have access to Kyocera's dealer site.
We have a Kyocera taskalfa 300ci in the field with a DP-750 type ADF, is it possible to fit the DP-760...
Yes. At one point they were running a little over 25 K a month but that has slowed down with the end of tax season. Out of all these AF 3350s we have out in the field, these guys are running it the...
Yes, all the tabs get pulled including that one. Nothing obstructing the toner path, it also doesn't look like toner is backing out of the dev.
Okay, the developer gets initialized every time a new developer was installed.
Hi guys,
We have several Ricoh AF 3350's out in the field, but we are having a particularly nasty toner spilling problem with one of them that has been going on for a while.
The toner spills...
Success!!
Thank you very much! Reloaded the firmware on a USB drive, FAT formatted with with less that 2gigs memory. Then rebooted to the normal screen.
Thanks :cool:
Thank you.
Do you happen to have a tech pub or document on this you could share?
Hi Folks,
I replaced a cracked touch screen on a 300ci.
After I put the ops panel back on and fired the machine up, and the screen was black while I heard the machine warming up. The memory...