m/c started off with f2-41 cyan toner concentration unable to reset or print replaced cyan developer and ran dev set up all looked ok no errors ran test print in service mode but no colour present...
Type: Posts; User: malthus
m/c started off with f2-41 cyan toner concentration unable to reset or print replaced cyan developer and ran dev set up all looked ok no errors ran test print in service mode but no colour present...
modified bushing available from minolta original one seized up in hopper and threw up code deepending on colour
known fault temp measure turn off sleep mode via service mode and set to off in admin mode and download latest firmware
throws tup f1-19 but never ontest and can some times run for amonth without error resets sstraight away
any ideas
exit drive bushing wears out causing poor meshing to drive to exit ,you can temporarly make a repair by turning the bushing through 180degrees but as this quite a long job it is better to replace...
u must be bored this weekend scott
[QUOTE=realmudd;368520]Hi, I have come to my wits end on this. During test mode for yellow, it showed dark yellow on the top and bottom edge, and everywhere else was an extremely light to...
this is not an error code but a built in counter go in to service mode and clear supplies counter i.e ozone etc ,usually comes round about 60k
[QUOTE=JustManuals.com;368590]This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:
Just Manuals, The Internet's largest selection of...
I have bizhub c25 constantly jams indouble sided mode have tried changing boards main motors sensors but the paper is not fed back in for second side and registers an output jam both clutches have...
more problems after replacing icp1 on pcb and checking the board on another m/c which showed board to be ok fitted full set of laser units blew the icp1 again help
either a problem with the bias connection to the unit or a problem with hv board .are cyan and magenta okand are there any warnings or codes regestering
yes 162 ,211,163 al take dv110
cheers mate u were right icp1 was blown on both boards . managed to replace icp1 ,which by the way also includes the black which i suspect is prime suspect for the fault as cyan is 1st to fire ,icp2...
what pairs fire up first is cyan and yellow or what
hi all
have this code on c253 c4151 replaced laser unit no joy checked all connections removed and reseated .replaced ph relay board and pcb and mf board still comes with same code it does reset...
has the firm ware been upgraded to allow contiuios use after life over has been reached if so oil can willbe displayed on control panel ,if is it a new drum you are fitting ie with a new chip to...
check condidition of nipple ontoner bottle if damaged replce bottle .also customer may have twisted moter while inserting bottle remove front cover and check spring for toner rotationlock if out of...
if the thread is closed please advise and close the thread ,sorry i have been absent for a while
malthus:rolleyes:
is the test print ie gradiation pattern ok ,are there any warnings ie p codes
no fuser roller available ,suspect your customer was doing full bleed a3/a4 and did not set tray thick 2/3 wiich will slow dow down printer buy a new fuser section and advise customer on settings
mfp board unless you have changed the iu. laser are all in one
fault is usally caused by transfer unit recycle unit blocking up and dropping toner down the right hand side dirtying detection switch.strip down transfer recyle unit ,vacuum out check for blockages...
inside the tray under the lifting plate are a couple of screws which slackened allow you to adust the side guides which also move the the black bar with cut out s for making width detection via photo...
cant seem to find clutch your talking about can only see motors in parts manual