Hey mate did you change the whole developer unit or just the yellow dev? Has the issue come back? I have the same issue on the same machine but i am getting yellow potential sensor errors 381-04. I...
Type: Posts; User: Bozz
Hey mate did you change the whole developer unit or just the yellow dev? Has the issue come back? I have the same issue on the same machine but i am getting yellow potential sensor errors 381-04. I...
Tried everything in there i could think to try. Maybe i was missing something with a clutch or something. Can you see the video?
Thanks for the reply. Can you view it now?
Hey i have a MP 6503 that makes a big clunk noise. Customer uses lock printing and says it happens when a print job is sent to the printer but not while it is printing. Usually its just in rest mode...
Hey Guys,
Have a MPC3503 that’s flogging the drums out what seems to be way too quick. The attached pictures are a colour drum that’s done 102 935 pages. Drum is shagged but charge roller and...
For anyone that has this i got it back in with a spring hook, a fair bit of swearing and i used a small bit of blu tac to get the spring to hold in its correct position while i slowly got the...
Thanks mate, i have the part the problem is getting it back into its position.
Hey i have had this actuator pop out of position from what i think is the exit sensor. Has anyone had to put this back in or had any experience putting it back in?
Without pulling what looks like...
Hey dudes,
Is there any printer kits or different options for replacing the drums in the mpc5503s? Something like how the 811s and 820s were able to be used?
Ordering the correct Colour PCUs...
Hey Guys,
I fixed this problem this morning. I thought when doing A4 tests and stopping it the image on the belt it was bad. After having a better look and doing A3 test i found the image on the...
No ripples. I bought the transfer belt from that machine and put it in our machine in the workshop and it worked fine.
The image is bad like the samples. I bought the faulty machines transfer back to the workshop and put it in our machine here and it worked fine.
I have the same machine at the workshop and swapped out the cyan drum unit and it did the same thing. It was a good drum out of a working machine. Just a test. That would mean it wouldnt be the dev...
Hey People,
These are what i am getting out of the machine from test print in serivce mode. Machine only has about 6000 total. Have tried different transfer. If i stop the machine i can see the...
Can confirm that the 820 colour kit and black kit will fit into the MPC 3002 with mods.
Hey Guys,
Can you use 820 drums in the MPC 3002? Is it where you have to remove the pins out of the back and change the wiring?
Thanks