Check the actuator in the exit section. It really wears down, and the sensor does not get an absolute reading. I replace these actuators every 1 million. It may look ok, but when you compare it to...
Type: Posts; User: dckm
Check the actuator in the exit section. It really wears down, and the sensor does not get an absolute reading. I replace these actuators every 1 million. It may look ok, but when you compare it to...
Will not copy or print, but scans. If you try to copy something, it scans the page, but thats all. Says everything is ready. No error messages.
New to canon. What is a
E000008-0001 Error Code? I have a service manual, and can get into service mode. I can't find this error listed. How do I read the code?...
Will instructions come with the firmware?
Actually, I used to clean them all of the time. If you take them aprt, you will see that they are identical, and really a spring cluth inside. Pull it apart, clean all surfaces, and put 1 drop of...
Ok, I'm a Ricoh guy, and have worked on various machines over the last 25 years. Many times, there are little tricks of the trade, and I want to know something. I bought a color drum for this...
sounds like something is arcing, causing the machine to get lost in space, or so to speak.
Which MFP, Card Reader, and application are you referring to?
===============================================
Blackboard cards reader. Just want to enable copier with card swipe. What are the...
Any info on connections?
Anybody have one to sell?
drichards@keystonebp.com
Ladies and Gents:
I am a service manager at a Lanier/Ricoh dealership. Recently we upgraded a few machines with Lanier machines. The customer has requested that we clean the hard drives of the...
Do you have "postscript" installed in the MP 2000?
I have about 60 LD433's equipped with SR 3050 finishers. The problem is the curl of the paper is just enough to cause the copy to roll up into a tube, consequently causing a jam, or misalignment of...
Check the four mylars in the toner hopper. I have also seen the 3 switches above the fuser cause this problem.
I have a few Lanier LD125s, that need to be cleaned alot. There is dust on the mirrors. We had a LD122 in the same location, and same spot, and hardly ever had to clean the optics. Anybody else...
Try D010 1186 or B291 1186
Check your drum ground to. A faulty ground will cause it to background too.
Enter into service mode, but hold the # when you press copysp. This brings up special mode, and it is in the "mode section" (A3 doublecount)
There is a connector inside the controller box. (opposite end of the board connection) Reseat it. I have seen this cause that problem a few times.
check firewall port 3670 in exceptions.
Clean the optics section.
I have an Lanier LD433, that puts two marks on the trail edge of the paper. It is coming from the drum scrapers. I stopped a copy mid cycle, and it happens before fusing. It also does it on a...
On the back end of the PCU, there is a small gear attached to a flag, that interupts a photocell. When you first put in the pcu, the flag interrupts, but as the drum cycles, it moves it away, and it...
How would you rank Kyocera in reliability? Muratec? Sharp?
I was wondering what is the best low end copier. Carry Ricoh now. Thinking of adding another line for the low end.