I do not have a service manual, the green light flashes 3 times pauses than 3 more time with the yellow fault light on. The screen that never lights is 5X7 screen with no manual push buttons.
Type: Posts; User: Techboy
I do not have a service manual, the green light flashes 3 times pauses than 3 more time with the yellow fault light on. The screen that never lights is 5X7 screen with no manual push buttons.
I am working on a 527F When power on the green light flashes under the Z than around thirty seconds the Warning light starts beeping and maybe another 30 seconds the power switch flips to off. The...
you always have sim 340 to adjust memory more towards the copier side rather than the printing
I played around with Kyocera Net Viewer, I could export a csv file, just could not figure out how to import it back in.
Agree with this one, I can do a 917 export everything, change the hard drive or main board. Export everything back in again, everything works fine except the custom boxes are always gone.
At set up I set the paper type to plain, 1 ring instead of two
I had one of these giving me fits, I ended up replacing the paper feed board in the large deck. Also I hope you have brought a ream of good paper from your office to avoid some of the paper issues.
I had a 3552ci with the same code, it ended up being the engine board
Firmware first, I had one that did this and the date and time was not correct. I put summertime on, and use time2.google.com and synchronize now.
No I have not seen or heard about this one, thank you so much.
Have one customer usually when they come in the morning this message is appearing. When they open and close the front cover it goes away. Firmware is up to date, sim 159 is set to empty, the toners...
I have a 6002 with a 1000 sheet finisher that is giving me a 6001 Jam Code, It jams when the first sheet is halfway out the exit of the finisher tray.
[QUOTE=blsquires;483429]before you do anything else go into service mode 671 and do a fax dimm clear.then do a fax dimm recovery.it can cure a lot of problems.[/QUOTE You have the machine plugged...