u with blinking light.
Service manual directs you to 303c, hard disk.
Strange thing is that after sitting powered down overnight, the machine started up and seems Ok today.
Type: Posts; User: jsolo
u with blinking light.
Service manual directs you to 303c, hard disk.
Strange thing is that after sitting powered down overnight, the machine started up and seems Ok today.
Hello,
My WC5855 won't boot, displays green xerox page with 'Please Wait, System Powering On' at the top.
Don't know where to start. Please help.
Found and fixed the issue. Thanks for pointing me to the right area!
Duplex tray is clear. Not sure where the inverter sensor is located. is it the optical sensor in the duplexer? That one's clear.
I'm new to the Xerox 5855. Got a paper jam this AM, cleared the jam but the machine won't clear the error. Fault codes are 383.190.00, 310.101.00, and 310,120.00. Tried cycling power, checked the...
Not familiar with mwce. What is the phone number?
I need a toner hopper assembly for a Minolta Di 650 or Konica 7165 (same machine - but you already knew that, didn't ya) or a 7155. I'd also be interested in an entire copier as a parts machine. ...
Can these two get along??? We're adding a 64 bit windows 7 pc to our network. I haven't been able to locate the appropriate driver. I'd appreciate your help. Same thing with Command Workstation....
Want to thank you for the replies. I got the printer going again!
Must have been oxidation, dust, or some sort of conduction problem. I just took the formatter board out of the cage and dusted...
I did the cold reboot, a few times. Also removed and cleaned the connnectors on the formatter and the jetdirect card. Now the printer will initialize with the jetdirect card installed. That's...
lj 4250 with jetdirect 620n card has been trouble free until recently. Now it won't boot with the card installed. Without the card it boots and prints via usb and parallel. Once the jetdirect card...
Looking to buy the supplies to do a pm on a c500 pro. Have an arrangement with my trained tech – I buy the parts and he installs them.
Need a 100k PM kit; a 200K PM kit; 4 drum units; developer...
Chicago area - next to the big airport.
I just heard from the shipping department - my Konica 7075 will be here next week! YEAH!! Only had to wait 9 years....
just kidding. Actually I am looking to buy an IP-601 with cable and board,...
There's no punch unit. Turned the knobs. Passed a sheet thru the paper path from console exit to the fold/staple unit. Didn't find any paper. Didn't clear the code. The display keeps flashing...
Can't clear the code. The console says to check/clear paper from the finisher, but there's no paper in the finisher. Tried cycling power - no effect. Not sure what to do next. Please help.
OK. Thanks much!
Would appreciate any help on reloading the firmware from the community...
I do have Command Workstation on two pc's, and neither one of them can find or connect to the Pi6500pro either via 'find' or inputting the ip (although both can connect to our Fiery S-300/C500). At...
Thanks for the post. I'm unable to print any reports (configuration, fonts, etc.). The Pi6500pro displays a 'sending report' message and then seems to time out and then displays 'canceling rip job'...
Our Fiery Pi6500pro / Minolta Di650 has stopped receiving jobs from the lan. The Pi6500pro just sits there idle with a solid green status light. The network router sees the pi6500pro and has given...