I have a T790ps that initially would not print. Tried to date:
Disconnected from network, ensured no jobs pending, tried internal print. Front panel showed PROCESSING then immediately said...
Type: Posts; User: EOJTech
I have a T790ps that initially would not print. Tried to date:
Disconnected from network, ensured no jobs pending, tried internal print. Front panel showed PROCESSING then immediately said...
Recently had the same code on a MP5054 with about 325K. PM'ed fuser (sleeve, pressure roller, bearings) and problem solved. No obvious defects with old parts.
After replacing the HDD (with OEM) and updating firmware, the machine comes to READY, prints a page with several short lines of varying lengths, then displays error code 46.23.3F. Service mode seems...
Have a 9050dn showing service code 0E17 (Failcode for self-execution test) after running service diagnostic (results were 0E17, 0000, 0000, 0000. 0000). I know that 0000 is good but the table only...
Have a scanner that was throwing SC101 codes and banding when scanning a document, through both ADF and on flatbed. Lamp, SIO board, and lamp stabilizer replaced. SC101 is gone but banding remains....
Has anyone set up a coin-op on the X7400? The hardware is not a problem (FDI is installed, type is chosen in service mode) but I cannot find any solid documentation on how to set up the communication...
Try doing a Shading Test from service mode (Diagnostics -> Scanner Diagnostics -> Shading Test). There is a service bulletin that states that the Shading Test must be performed after ADF or main...
Does anyone know how to adjust the page count? Had a machine with about 25K clicks that suddenly started reporting about 2K. No repairs have been done to the printer, and no error codes recorded....
After a lot of tinkering with settings changes, and checking for hardware failures, the solution turned out to be reinstalling the firmware. It was already up-to-date, but after reloading it,...
Have a ghost image on print only that is 94mm from the original image. Roller pitch guide suggests fusing sleeve or drum. To date, fusing sleeve, pressure roller, K drum, ITB assembly all replaced,...
Large RX faxes (>10 pages) show as being received OK in the fax report, but not all pages print and there is nothing in memory, as it is set to always print. In one example, a 20 page document was...
Thanks for the advice, and be careful what you assume. I was unaware that a background check was a prerequisite for participation. I have been to training, and I did find the answer to the question.
How do you enter SP mode on a LP235N?