I see this all the time lately, just go into "services" and "stop" and then "start" the "print spooler". go back to your printer window and you should see it listed.
good luck
Type: Posts; User: Brianneoe
I see this all the time lately, just go into "services" and "stop" and then "start" the "print spooler". go back to your printer window and you should see it listed.
good luck
It’s a known problem, the transfer roller in the belt unit is stuck.Remove the belt and clean the ends of the roller.
good luck
if you have a Savin you will want to download the ppd for MAC from" support.ricoh.com/bb/html/dr_ut_e/sav/" When you the add the ppd on a MAC and you use the wrong brand the MAC won't see it...
Same issue on a 7503 turned out to be low voltage below 110 coming out the outlet. Spoke with the building maintenance and they did their magic and the problem went away.
Update the firmware package and then the App package.
Issue is with W11 and the MS driver..No problem using the correct RFG driver.
Replace all the filters..
This is a common alarm and it will slow down printing by half
"He claimed that I should have known that and that I had put the customer's network at a very high risk...."
The IT guy was right but he is also a Jerk. Shake it off and get on with your day. Some...
Cannot Print PDF Files From Acrobat Reader in Windows 10 FIX - YouTube
Good luck
Open the ppd and select..Printer Features..Paper..Banner Page On..The setting on the machine needs to be set for the tray just like a PC driver. I.E.set in the Printer setting for the paper tray...
are you using the ppd for that model from the Ricoh site or are you using the apple generic ppd? The apple ppd is basic with a lot of options missing.
Remove the Fax board if it has one
There is a bulletin going back to 2019 about the exit unit screws not installed correctly causing exit jams. The solution was to replace the exit unit. D0BQ4404
SP 5811-011 is the NCS reset. Scan to network problems can be a scan to email or folder issue, you don't state the one that you are having problems with. If its scan to folder make sure firmware is...
If you hear a clicking noise it means that the bottles "flippers" are stuck and is not turning.Very common with this series. Make sure you can turn the left side of the bottle. You may just have a...
On the MAC press Command,Shift,and the letter A at the same time. Go to the bottom and open Utility. From there you will launch Terminal.Use the telnet command just like on a PC.
Type in "smb...
Same here..Had an off lease machine missing the seals where the cyan DV unit met the toner hopper caused the sensor to get contaminated quickly.Took me a couple of trips to figure out that that was...
Just for clarification, The ITB lift motor is the Cyan Toner Supply Motor. That is the ITB motor that you replaced? If not you will need to replace it.
If the machine sits there and indicates "processing"on the display you have a hard drive that's going bad.
Good luck
Go into the SP mode and check the last error code. You may have a hidden fuser code.
SP 1960 Optional Paper Setting Enables installed options: Roll feeder (1 or 2 rolls),
paper cassette. This setting is not necessary if no
paper feed options are installed. (The default setting
is...
From one of my older post :This is after you load the manufacture ppd. You did not state if the unit has a Fiery print controller. There is also more info on CTN on how to properly load the ppd. All...
You can program it in the same way as Slim stated in the scan mode.
Many thanks if you can also send me a PM. It would make my parts manager day!
I had this problem a while back..Unplug the machine and discharge it by pressing the power switch. If the OPE is set for Quick recovery mode (default) it will bypass the Quick mode and allow you to...