[QUOTE=dallas;349121]If I understand you right, maybe this countermeasure helps.
A piece of DF cleaning pad, insulation tape or something can be used to enlarge the space.
20012
Thank you...
Type: Posts; User: shamnad abdullah
[QUOTE=dallas;349121]If I understand you right, maybe this countermeasure helps.
A piece of DF cleaning pad, insulation tape or something can be used to enlarge the space.
20012
Thank you...
thank u @laitang
Sent from my Redmi 3S using Tapatalk
I have a ricoh spc311 printer which giving an error code of sc 300...Does anybody have any suggestions how to solve.....
Your assistance in this matter is greatly appreciated.
Sent from my Redmi...
But I couldn't find any DIMM memories in the main/engine pwb..
Sent from my Redmi 3S using Tapatalk
Hello friends..I got a machine with error code F000 and some times it showing code 3500...I checked all the contacts.my question is can the main/engine pwb be the culprit..Or any other solution
Your...
I encountered a couple of times this problem due to a sensor inside the drive unit
First of all goto maintenance mode run item U150 and confirm both 'container set' and 'container sensor' working...
me too...any solution?
hi guys,got the new PRCB today,it vanish the code and the machine is working fine...
thanks for all the replies
you r right..actually that machine was in contract with spare parts...to change the laser unit would cost more than contract amount..
make sure that the user authentication is off....try to clear all account data
I got the same code about 8 months ago..it takes about 2 weeks to find the problem.it was due to laser unit.remove the laser unit and clean it,especially the edges of the polygon motor .
gud luck
[QUOTE=Orion2010;478086]hello all,
i have samsung scx 4300 and take 3-4 paper one moment, and paper jam in fuser ?
Its probebly due to multi paper feed at a time .check the seperation...
When replacing the BICU, remove the NVRAM [D] from the board. Install the
NVRAM to the new board.
The pick up solenoid on and off timing depends on trailing edge detection by the paper feed sensor.I thing paper feed sensor of your machine causing this problem.This sensor also controls the paper...
Remove the high voltage board and assemble it,make sure that all connections are touching properly
best of luck
i think your machine isn't detecting the actual paper size from the feeder.
mostly copytechnet has some threads of the code that i searched for.i suggesting you one website,i thing it works better PrintCopy: Service parts repair manuals for printers, copiers, fax.
thank u
i already swapped the fusing unit..
hi guys.I got an issue with new bizhub 501with an error code C-3903.I reset the code but again its showing.I have swapped out the fuser unit and the power supply and reset again,but the code is still...
change MFP Board and check.while putting new MFPB use the parameter chip(U16) of the old board
check the connections between MFB and laser unit
: How to Change the IP address of INEO 250
press utility/counter=>admin management=>enter"00000000"(default)=>network settings=>ip adress settings
here you can change the ip adress....
try to change drum unit and developer together...
try this
go to service mode (utility-check details-stop-00-stop-01)
go to imaging process adjustment->perform D max density
gud luck:)