its a electromagnet. A switch in a simple term
Type: Posts; User: pradeep.n
its a electromagnet. A switch in a simple term
May be you can check if the solenoid is closing at the time when you close the tray. ( you can check the same in the SP mode 5XXX, dont remember which code though)
Update on fusing unit.
1. AW11 0059 Thermostat:190C - CH152(make) - reads 0.4 to 0.6 ohm. which is as per manufacturers spec.
2. AW11 0058 Thermostat:177C - CH152(make) - reads 0.4 to 0.6 ohm....
it also gave me a SC565 hence did this bit as well. and about putting machine the on fire, customer might summon me later. :P
ANd i forgot to add, the range in the meter is in Mega Ohms, so each reading is in Kohm range. ( 201 K,206k,147k like that)
I have noticed that the developer unit is rotating.
Everything seems to be fine, yet something is wrong i feel.
2947329474294752947629477
i checked the fusing unit.Thermistor has 203 K to 200 K...
i took the entire pump unit off the machine, cleaned it outside. And the hose as well.
i still am not sure if the pump is faulty or some other part has failed.
appreciate your inputs on this.
...
it says independent toner supply Oze.
noted, will have a check on the nozzle as well
okay, will try that. Im still having a doubt if the black toner pump i received is working fine. Because i dont see any black powder inside the tube, nor the pump itself. Bizarre right.
Will try...
ah well i shall check for the chips once. my fear is, once we had tried to use working machine's toner (OEM) into a faulty machine.
then the working toner was dead. hence taking all the...
yes, the bottle (BK) turns when the machine boots up
hello slimsob,
i've replaced the toner pump, and yet it doesnt recognize the black toner.
is it possible that the toner chip's play might be involved in this one? or any other part has been...
thats kool.
thanks for the info polarbear.
Hello All,
Please let me know the advantage of upgrading the firmware of the machine.
What could change. ( Is there any dramatic change by the way? )
Thanks
Agree with all of you above.:o
right, so once we are inside the motor, we can come to a conclusion.
if you are familiar with electrical drives, may be you can spend a couple of hours to service the pump if it is in half working condition. Else, replacing is an affordable option.
what is the LCD status displayed as?
Had run into same prob for a customer once, fuser was the thief.
please check the head and drum once.
there is a switch which closes when you close the cartridge cover. seems to me that its havin trouble.
Possible soln : try opening the machine, and check for the switch. If faulty, needless to...
Possibly a pin or multiple pins are not able to communicate. Please check if they are depressed.
please try a page alignment as well. with the above suggested upgrade.
i believe you are referring to the sensor which is either faulty / broke. Please post a pic