fix to page will stretch the image, it needs to print 100% and is not doing this, the image is shrunk by and 1/8 of an inch in the width, i will include a pic. There should be an setting in service...
Type: Posts; User: marklk
fix to page will stretch the image, it needs to print 100% and is not doing this, the image is shrunk by and 1/8 of an inch in the width, i will include a pic. There should be an setting in service...
when i send a document to the copier, ie, 3.5x2 , 12 up on 8.5x11 sheet of paper, the crops a not measured all the same, some show 3.5x2 and others show 3.5x1.875, its shrinking, is there a way to...
Thanks for replys, is there a way in service mode to shut the SC error messages off?
sounds like it, ive also seen SC442, not sure what that is
thanks for all the help, im seeing an error code SC367, any ideas how to fix it and whats causing it?
i did get it to start printing darker black by turning the bottle by hand , is it very hard to get to hopper auger or motor?
thanks for the reply, how do i run the bottle motor in output mode?
Thanks for the reply, the last toner set we bought was off ebay, and i believe were refills, the black shows almost empty when its actually full, probably the computer chip needs to be changed
Thanks for the reply, how can i tell which is the problem, when i open the right side the cylinders are all spinning, not sure where the sub-hopper is? Is there a way to manually force the black drum...
i have a problem with the black printing gray, we just replaced the black pcu a few weeks ago, it was fine now its printing light black again, is there a way to manually force toner to print 100%...
i have a problem with the black printing gray, we just replaced the black pcu a few weeks ago, it was fine now its printing light black again, is there a way to manually force toner to print 100%...