Search:

I had a few cases where the machine powers up, but nothing is displayed on screen. when you look closely you van see a SC202 on the screen, but no backlighting.
in this case replace the BICU and...

most of the times the originals get skewed along the way and end up bumping on one of the spacer nibs on the guides.
Some cut of these spacers, but it's better to look at the source of the skew.
...

Try replacing the toner sub hopper, might be clogged. (prepare to undo a lot of screws!;))

hey guys

I've got an mpc305 with SC code SC545. after reset it's ok for a while, but always return after a day or two.
The fusing unit and thermopile have allready been replaced, but no luck.
...

Agreed, happend to me once, the charge cable for the Yellow transfer roller was broken.
Might also be the contact springs to the itb that are bent/broken.
Also check the conections on the high...

Did you update the firmware of the machine? especially the java update fixes a lot of issues with PCC.

The interupting will only begin after the job is completely scanned, so when Sorting is enabled and you scan from the exposureglass it will only start after you press '#'

I dont know if that is even an option. When the forward fails the machine gives a 'Network Error' in the fax function, and stores the fax in the memory.
It can be retreived in the Web image monitor...

This code accurs a lot less often if you let the driver "spool before printing" in the 'advanced' tab of printer properties.

could you include an example?

Is there an inteval between these ghost images? (every x cm)

29857
Did you happen to build over the part in red (that is the ground plate) if you replaced pcu and developerbox as 2 units; you need to salvage this part from the old pcu.
I dont know if it is...

You will need a fax-unit installed for mail to print to work. Sounds weird, but they should have called it mail to fax.
there are also limitations like only the first attachment is printed, and only...

depending on the finisher, the shift tray can be pushed one notch too high, unable to recover because the sensors do not react as expected.
remove the back cover and drive gear to move the tray...

Is it an even background, or an assortment of dots with a pattern to it?
(in case of the pattern, this is normal)

You can easely check by pushing the duplexunit inwards while printing a test page. if it comes out good (or at least better) it's the ptr pressure.

Looks like dirty developer to me too, or dust on the shield glass. You can check by detaching the developer unit from the drum assembly and checking the mag roller.
If less dense stripes apear,...

hope to be of help to someone