Very keen to here the resullts
Type: Posts; User: TCA TECH
Very keen to here the resullts
Increase the suction fan on all paper modes in service mode and set Print head height to strong . i have had this issue for weeks and that is what seamed to fix issue. never looked like hitting the...
Hi Guys,
Looking for any help with a Ricoh Wide Format.
Since install customer had lots of jams, ricoh having me increase suction fan, adjust print head height (abrasion) and update firmware....
Well i did sort it out. So much for the OCE expert who came on a 2 hour drive and actually caused the issue.
With your help and my knowledge of copiers i just started to follow the process of fault...
thank mate
Thanks Mate
Hi Guys, Does anyone have any experience on OCE TDS 450 plan Printers.
When a job goes to it, it feeds the paper to a certain point (same point every time) and then the printer display shows...
Hi All,
Sorry is been discussed before.
Is there any tricks to save some money on the 003 and 004 series machines. With drums. Like we did with older models?
thanks in advance
No Paper , but will replace SW7 as a just in case. thanks
Hi All,
I have a ir5055 that after a jam, fuser area the machine just will not reset unless i turn on and off.
Any suggestions other than rear fuser wiring loom and plug ;-(
yes old and lots...
Lagonda, could you let me know the part number you are using for $70 dev unit. If that is the case I too would just advise replacement. At $1500 for a PCU, interested in OEM
Just check latest...
Hi All,
Been getting way too many white line issues on dev units. only real fix is to replace the dev unit. Issue is a buildup of lumpy toner behind the doctor blade. Old school just remove blade...
White lines caused by lumps of toner in the dev, replacing way too many devs way too early.
No the motor didn't actually fix, it made it better(or thought it made better) for a while. It was the foam rollers on the stacker. I dismantled cleaned put a bit of silicon and never played up since
I will turn off Potential Control and up date firmware as my next grasp of thin air :p
Thanks for all the replys
After returning with dehumidifier installed in room for 2 weeks all moister was gone. Just the developer spill that customer thought was same issue. new dev and should...
Yeah good question, not booklets. Just A4 covers on A4 prints with inserts stapled.
thanks
I tested from both draw 3 and the bypass, same issue. Even using same draw or bypass for both.
No copies with me, but the blanked edges are also blacked out, image is still on the page if image was...
Hi all,
I have a ir5055 that when doing booklets with cover and inserts the cover and inserts get darker and darker to the point they are black. it is edge to egde. all the standard pages in the...
Hi all,
Need your ideas,
have a mp7000 that is in a small room that is airconditioned and get lots of moisture about the fuser unit and drips on to the drum causing a blurr affect, by 100am is it...
Yep, same issue and ricoh said bulliten to change polygon mirror motor and bicu, bugger
New MP301spf out now?
Problem caused by binding on the foam rollers and idlers to the belt on exit. This just put too much load on moter that stopped with the slightest amout of extra resistance. Only found after I...
Problem caused by binding on the foam rollers and idlers to the belt on exit. This just put too much load on moter that stopped with the slightest amout of extra resistance. Only found after I...