I suggested to create user code for per user, or create a user code when print colors ( this might be a easiest way).
Type: Posts; User: techshare
I suggested to create user code for per user, or create a user code when print colors ( this might be a easiest way).
when place papers into bypass tray, you should look at the op. panel display in small words: select the "#" to set up paper size. Otherwise, it does not know.
I agree. There are no easier way to search for anything anymore.
I agree with Jummamaster. Check hot roller bearing ring, be sure it in place.
I have the same wrinkle problem, when try print to envelope. I did talked to Ricoh Tech Support, they have recommended to get envelope with smaller flap.
GOOD LUCK!
Yes, I have check the PS, even got a different one. I did print out the configuration page to verify, and it shows PS3.
I can't seem to get Mac to print on this unit. Data light blink, but will not print?
Thanks KopyKat. I have clean the unit, replaced the LD, performed the adjustment.
I am working on Ricoh 3045 with SC322. I noticed copier function and scan feature are working fine. Only when you try to print or machine try to print out fax confirmation, it show a red wrench SC322.
I believed you got the chinese version control board.
Check the adf lift sensor or paper tray end sensor, either one it just out of position.
Go to user tool/general setting , change email size to 50mb. Then, go to scan feature turn off email size and devide setting.
according to TSB-034 Reissue on 02/13/09. It is a whole complete dev unit.
Ricoh has upgraded the dev unit sleeve, and new part # D0092301.
Check tray position sensor, one time I found it got knocked out just a tad. Good Luck!