Search:

I agree in principal but Papercut seems to be the only connection, still not resolved Kyocera have suggested power supply, I'm sceptical to say the least.

Thanks Tony, yes have tried that. This occoured on 4 devices on diferent sites over the Xmas break. It's very odd to say the least it's almost a virus like issue.

Hi I have had several machines not booting (staying on the "Kyocera screen") no errors. SSD , hard drive and main PCB replaced , firmware reloaded (latest, skip file removed) . The only clue is they...

The finisher does not make a good connection with the machine , you will notice the connector "floats" on the finisher unit. Pack this out with a washer to fix the connector and bring it slighly...

Hi
Yes you can replace the cassette with the spring loaded type from the slower model in the same series of printers, you have to break off a tab on the left of the cassette to get it in, it's...

Hi
I cannot find the firmware for the taskalfa 307ci on the Kyocera .eu website.
I do have a login. Dose anyone know where it is?
Thanks

Thanks for all your advice

Hi
Hope someone can help. HP MFP M880 with 30.03.23 Scan Calibration error and intermittent 31.03.34 Background Unit not located.
The calibration error comes up after warm up , I have tried to...

Hi. In my experience lasers give more refined lines.is the paper damp, or environment damp?

Hi so you put this corona unit into another machine and got the same problem? If so replace the unit.
Thanks

I would suspect primary corona wire/grid, get it out and give it all a good clean.

Hi
Who moved the machine? I have seen these connectors damaged as they are pulled away without disconnecting the network cable.

Hi also make sure you have latest Firmware, I have updated and it cuts down on this issue significantly.

I'm a tech

I would suggest you have a drum earth problem, either with the coating or earth tab in the drum.