Having a problem with a C6500 that jams up when duplexing with the codes either C-3206 or a C-3209. Both stalling out in the decurler area and not going into the duplex. Pretty consistent although...
Type: Posts; User: CopierCare
Having a problem with a C6500 that jams up when duplexing with the codes either C-3206 or a C-3209. Both stalling out in the decurler area and not going into the duplex. Pretty consistent although...
Thank you everyone for the help and suggestions. Not sure what original problem ended up being. I went out to verify everything my tech was telling me and found the post holding the sensor assembly...
They have all been replaced very recently. Two weeks ago.
Have a C6501 with a C-4521 Fault. Have switched out color registration sensors, Transfer belt, transfer belt assembly, Printer control PWB. Test sheets in adjustment areas of service print out fine....
Thanks I will give those a try and let you know.
Yes. Thank you for the reply. That is what I am doing from the service manual. The problem is that it does not go into the PCB replacement mode following third instructions. It just goes back to...
I have a Canon IPF 8300S that I had to replace the Main PCB on. Problem is that it say to hold down Load and navigate and ppower to enter in to PCB replacement mode, but does not go into it. It...
Upper lamp fixed it! Thanks for the help
Thanks for the help. Even though it was pointing to the lower lamp L5 it was an upper lamp L2 not lighting. Ordered lamp and will let you know.
Yes. I am sure the lamp is good. also checked circuit all the way from and back to AC Driver Board.
Yes replaced with correct lamp
OK I really need some help here. I am desperate. I have a C6000 that get a C-3509 fault then after reset warms up forever then gets a C-3912. Upon inspection the lower fuser roll never heats up. I...
This MX-C311 is way off on color. Too Magenta. Tried to run color balance sim 46-74. Prints out test sheet and goes on the glass and reads but never prints out second sheet. Just sits there. Also...
Anyone out there have a good mobile invoicing program that can be used with quickbooks to do onsite invoicing?
I clean the rolls up each time I replace the fuser belt. I use alcohol. May dry the rolls a little but cuts through the grease and I haven't had one dry out.
Thank You everyone for your help and post. Having the right Install manual was the key. Machine now running like a deram:o:o:o
Thank you "Elmo" you helped me solve the problem. I got it right after you sent the pdf.
Thanks "Elmo". I will try that. You wouldn't have a PDF of the installation manual you would be willing to send me?
Yes did the Gradation and Stabilization. and I think there in lies the solution. But probably not doing it in the right order or time in the process.
Also E parts room has boards and some assemblies. www.epartsroom.com
Have you tried www.iteminconline.com.
I did set the clock service with the Stop 1 1 4 4 C. But here is not a setting for the time zone there like the C224E.
I agree that I am probably using the wrong steps. All I can find is an Installation Manual for the C224E. There has to be one out there for the C224 not the E version. Because the E version does not...
I have a C224 that I just received. Has 80K clicks on it. When I color copy only I get evenly spaced cyan line then magenta line top to bottom. all other modes of print are fine. I know this usually...