Search:

Hi

Hold Numbers 2 & 8 ( in keypad ) and POWER ON the unit.
Enter passcode 885 to access Service Mode.

Cheers

hi,
try 700-396 = set to 0

I tried the partsdrop - but they dont have fuser roller.
Any other suggestion ? thks.

hi,

Any one knows where to buy the upper Fuser Roller for this model ?
The Fuser assy is very expensive - i would want to source the roller to replace & extend the life.

thanks for ur help...

try replacing with a new mob sensor.

check the developer ( k ) clutch - it is mounted in the main drive assy !!

hi, this error happens due to slow down of motor speed.
You may want to try clean the brush contacts to see if it helps.

good luck - do post ur test result !!

The Error code is 010-906 Fuser Unit End of Life
Thks for ur response.

Hi,

Anybody knows how to reset the Fuser life span in AP6000 model ?
Thanks for ur help.
VERY URGENT

:)

Hi,

anybody got idea how to clear the fuser end life prompt in ap6000 / ap7000 ( volante model ) ?

Appreciate ur help

thanks in advance.

hi,

the laser unit error could be due to the poor contact of the flat cable.
Flat cable contribute to error codes related to ROS. Try replacing the Flat cable - if problem not resolved then try...

hi xcopytech,

Tried with upgrading the firmware for mfc - but no effect.
Any other options or suggestions ?

thks

Hi,

Fuji Xerox DC156 model - just refuse to boot up at "power on".
The screen will display only the fuji Xerox logo & the m/c would hang there forever. ( god knows why ?? ).

Anybody to...

you can try to reset back the prompting toner cart - by sliding the metal plate near the gear at the rear of cartridge. this will reset the prompt & cheat the machine to treat it as new cartridge.

try replacing the ROS assy.

HI,

I had a similar problem & it was caused due to NVM value of ATC sensor setup - corrupted. Pls chk against ur machines's Birth cert. You also have to chk if the ATC sensor / dev tank assy has...

have u tried to upgrade the firmware - this is due to comm error between ess & iit