Search:

The pre fixing feed driver was replaced, no change. I will be working on the unit this afternoon...will let you know. Thanks for the help!

yep...tried all paper sizes. The assembly is mounted correctly, the 3 connectors are all intact, with new belts and a new sensor. Physically, all is fine. leaning towards the DC controller 1-1....

No... ps200 is in the transport assembly going into the fuser. This sensor has no flag.

Correct. 1.2 million copies on the unit. Client bought on ebay...so no p print available.

Hello...i am installing a used c6010s in a customers office. everything is all connected and comes to ready just fine. Every copy jams over sensor ps200 (just before entering the fuser). I changed...

Ok...got it connect...but now says to check power and video cables....

Haven't tried that...i will give it a shot.

Thanks...but that was the first thing I tried. I think I need to set the subnet mask and gateway...but those options are gone.

Additional info: the printer was setup for an oce prismatic rip. I'm not sure of the procedure to change the setup for the a1200 server.

We are installing a used oce prism rip to a canon c6010s. Rip connects and boots fine, but is in metric mode. To change this I need to get into rip service mode which is password protected. Can...

We just purchased a used 6010c without a rip. We had a used 1200 server to hookup, but the systems manger in the 6010 does not show anything other than proxy settings. Is there a setting somewhere...

I saw teckats earlier post on the led arrangement for PS diagnostics. It appears all the let's are activated. Still looks like a connector....

Ok...i checked the hopper driver pcb...connections secure...even swapped out the yellow driver with magenta...same code. Checked the yellow drum driver pcb...also swapped with magenta. Same code. ...

Cool..ill look into this again. I must gave old manual...nobe of these codes are referenced. Thanks...ill let you know the results.

Ok...i seated all the connections to the yellow hopper...and the code changed. Now the error code is e260-101d-5. 24v issue.

I had to remove the dc controller assembly to service the waste toner buffer unit. Replaced the buffer with No issue. Now the printer immediately signal error code e0260-2017-05. Power supply...

worked perfect! thank you!

here is the fix: i found this on an earlier thread from khattab.al.masry. worked perfectly!!
1-init-itb
2-itb-edge
3-intr-ex
4-at-img-x
5-auto-img
if this sequences failed you will have trail...

After restarting the yellow starter, i am experiencing a radical color displacement. i executed at-img-x, auto img with no change. also tried LD adj for each color. also reseated connectors from...

Looking forward to learning and perhaps helping!

I am pulling an E061-001 code, and have determined the cause is the potential sensor wiring harness. (The connector is shot - big surprise :))My question is, can i purchase just the harness, and if...

C

can the harness only be ordered? If so, would you have the part number?

Can i order just the harness? if so, would you by chance have the part number?