is printer management on in user authentication management?
Type: Posts; User: salmandol
is printer management on in user authentication management?
I did a full re install of software and problem was solved. Thanks
i installed the patches and still getting sc 919. the machine still cannot print any type of file. Any other ideas
Good day all. We recently obtained a used Ricoh pro c901s with a fiery e-81 that gives a sc919 when you send a print. I was wondering if this model needs a USB dongle as we did not receive any with...
thanks much
good day does the ricoh mp 8001 support printing direct from flash drive or is it only able to scan to flash drive?
mpc 4500 has a set of rollers in back of transfer unit, the spring hooks that holds it place break. not sure if the mpc 2800 has the same. Honestly never experienced it in mpc 2800 but it is very...
i swap yellow and black pumps when we are out of stock. so client could at least get blk copies.
might want to check hdd also
thanks much. will try tomorrow.
I am not seeing any GDI drivers on USA site. was it there u saw it available?
I am trying to install printer on win 7 32bit. it says no driver found eventhough I installed it. when I install printer manually and send a print the machine cycles and nothing prints. no print...
positive. i swapped back the old board and problem came back. weird huh?
i have learned that problems are sometimes caused by the furthest thing related to the error code.
thats why i like to...
is the text ocr scanning feature only available in the mp c4500 efi?
turned out to be the paper feed circuit board....
i tested machine from the by pass only and it works so i guess something in the lower feed section is the culprit...
hi all, sc 990 comes after 1 copy. replace all circuit boards, tested with working dr unit. could it be coming from laser unit. thanks in advance
also check switches above fuser
i have replaced all parts (gears, bushings, pipe) and the damned thing still makes noise. I have a colleague who heats the pipe and gives it a slight bend for the gears to mesh better. I recently...
could be caused by faulty door switches also...just in case
paper orientation could be the factor there, cause if you're running 8 1/2 x 11R it would not pass along the whole length of the guide. i have gotten this problem so many times already.
he said when he changes paper orientation the problem is gone, so depending where the toner build is or which probe is broken it can still be a fuser problem. don't get me wrong i am not dismissing...
check for toner build up on fuser entrance guide and also the small tips on the guide can break causing creasing.
i believe it uses ide laptop hdd. not sure of max size but usually 20gb is installed
providing you replace dr and dv run td sensor adjustment