Snap the pin off and it will fit and work
31647
Type: Posts; User: Bizhub
Snap the pin off and it will fit and work
31647
Hi all
Please feel free to have a look at WWW.CHIP-LIFE.COM for the new C220 224 360 364 drum and dev unit resetter.
No top ups , no computers, no batteries required, no removal of units and...
I agree we have too many customers ringing up complaining that the units are overlife !
That is why we use the resetter for the C220/280/360/224/284/364 + E machines.
Look at www.chip-life.com...
You will need to upgrade the firmware to get rid of this problem.
I would suspect the battery pack on the NVRam is shot. The code can appear every hour and yes S07139 will clear it (for an hour or so)
I would download from K-M NVRam recovery tool and firmware it...
We have had loads blocking up, tried antistatic tapes etc but to no avail.
Now Katun have launched the toner so hopefully the problem will go away with pulverised toner !!!
Could also be your image control board failing.
Fuser drive gear box on the back of the machine has probably fractured causing the gears to come out of mesh under load.
Completed back end strip down , Good luck !!!
Sounds like the CCD is down. I would always check ALL of the icp's first though
Don't forget the new passwords as K-M say if you forget them you would need to replace the MFP board and the SSD chip.
Hi all,
Please be advised that the new resetter that DOES NOT REQUIRE any chips to make it work has arrived.
These resetters are designed with your engineers in mind, they are small enough to put...
Hi All
Hi All
As everyone has said .................................
Fit Du104 drums and throw the 102 (A B or even C's) into the bin. This is becomming more and more the norm for K-M ! They keep cutting costs...
Stick this on your machine and read the small print !!!
1. Release version and download file name
Following program version is explained in this file.
[Release version]
The 6500 only supports 300gsm max as everyone else has told you.
But if you have a banding issue on 300 gsm, go into paper setting folllowed by process adjust, then go to the final page (3) and set...
It's finally here .......................
Check out WWW.CHIP-LIFE.COM
Try Copierchips WWW.COPIERCHIPS.COM they can help you with all your chip and IU needs
Regards to everyone
:p
Now here to buy !!
Visit WWW.CHIP-LIFE.COM
Go into service mode, then image adjustment and then turn off DEV BIAS CHOICE.
Now you should be able to grad adjust your machine.
Change the printer control board !!!
It will be the board !!! I only wish my handwriting was neater now
:)
First of all update the firmware on the machine, when you fit a new board always update the firmware.
Does the flaring happen only on prints or does it happen when copying also?
If it is a print...
I dont suppose you know if there is a part number available yet for the fuser guide plate (the one that customers snap off)
:)
Symptom:
After switching ON the main SW, C-3C50 appears on the display.
Cause:
In case, environment where the machine is placed gets under 10 degree due to
winter season or any other...