WC7328 machine has problem with ghosting in REDs. White not filled areas appear as more dark in red solids. I know how to resolve this problem on DC250/252 machine correcting NVM values. Is there any...
Type: Posts; User: sengineer
WC7328 machine has problem with ghosting in REDs. White not filled areas appear as more dark in red solids. I know how to resolve this problem on DC250/252 machine correcting NVM values. Is there any...
Here are some photos of my problem ImageShack© - Gallery and comments. When printing on heavyweight2(3) very often appear trail edge deletion like in "IMG013.jpg"
In other words unfused toner on...
Thanks for NVM . Thought about increasing oil dispence but didn't find an instruction. Don't remeber if it mentioned in EDOC.
What range of adjustment does this NVM chain provide and in what units...
Current version is 1.231.11. I'll try to reload IOT sw as soon as get CD with 1.231.15
Does it support russian language?
I'll inform about it a little later
1 or 2 month ago creo was updated with latest system software and SP because of customer was complaining that machine often asked for "null x null" paper size in MSI instead of one that had been set...
Customer complains about abnormal machine behavior. He sends job from CXP250 to MSI on heavyweight SRA3 and load half of necessary stock. Getting out of paper DC asks for A4 in Tray1! Not SRA3 in...
After resolving problm with sensor or somewhat else don't utilize old cartridges detected as an empty, disassemble them, collect remained toner and refill the half empty working cartridge in machine.
Usually I clean oil filter, tubes and wick from dirty oil. Steel metering roll and external heat roll I clean with strong solvent. What about donor roll and heat rolls. What fluid can be used if...
Dear engineers what do you think about dc12 that used mainly for printing heavyweight materials about 250 gramms/m2? How to obtain maximum fusing quality and not face with insufficient oil...
Thanks. I've found man resetting this chips for few money :-)
Can anyone help with NVM chains to change from default value (100) for higher one so encrease transfer currents on heavyweight. I lost that Eureka bulletin called "Poor density on heavyweight" or...
Check developer housing and screws holding the Trimmer bar in dev housing. Sometimes screws holding the trimmer bar in place in developer housings rotate relative to their initial position and trim...
This is so called External heat roll used for providing additioanl heat to the Heat Roll during prints on extra heavyweight materials. Often i clean it with strong solvent (In my case in Russia it is...
How can i do this? Do i need special device or it can be done with program like ponyprog and selfmade programmator?
My wc7328 machine ask for replacing one of drum cartridges and one at end of life... Drums will be shipped into 2 weeks or so... Can I unlock this? I found there information about DocuColor 240 and...