Sorry to revive an old thread, but what was the fix for this? Seeing it happen more and more...
Type: Posts; User: Konicatech
Sorry to revive an old thread, but what was the fix for this? Seeing it happen more and more...
I have changed countless fusing units on these machines (c250i and c300i) all because the toner was rubbing off the page.
Anyone else experiencing this? If so do you have a fix rather than...
Know people have had success converting K Dev units to colour dev units on the 4 and 8 series machines, has anyone successfully done it on the I Series?
Ok so if cyan and magenta are showing the pattern then that narrows it down, could be needing new C & M drums or could be needing C & M dev units, or could be both!
What toner is the machine...
AA2JM72Q00
I remember installing a lot of these machines when they were first released and thinking they took an age to boot up properly.
Update the firmware and I think you will see some improvement - ...
Make sure the print drivers are using the IP Address to print to the machine and not WSD
Had same issue recently, was the CPU board.
Assuming you don't do much work on these machines, but yes the dev unit opens up (that's how you empty it to replace the developer) You should check the roller and see if something is stuck on it,...
Had this problem myself, and unchecking the 'SNMP Status Enabled' option allowed me to get the machine printing again until the colour toner arrived.
will work as long as on the MFD the option...
Thank you all, I will try out the methods listed :)
Scenario - customer receives documents to print, opens them in word and tries to print them using the driver settings but Microsoft word prints them using the page setup and things print from the...
Does anyone know if possible to change the admin password from the web interface rather than doing it from the display panel?
Thanks
Open API Tool/Manager will remove it provided the tool is configured properly.
Otherwise set the device up on Papercut and remove it from there.
Sounds like a lot of hassle, can you not just get the correct card reader from KM? We usually use ELATEC or Ysoft readers and get the LDD from KM..
I have had this more times than I care to remember, do the following:
1. Take the chip off the toner cartridge
2. Install the toner and let the machine get to ready state
3. Take the toner...
I think you might be out of your depth here, if you start swapping boards around as said above you might end up with 2 broken machines.
They are not on firmware version 7, they are on function...
Fair, they are good machines anyway and consumable prices are low if you buy drum rebuild kits etc.
Re: things turning when you are not using the machine I wouldn't worry about it if it was me :)
What monthly volume is going through the machines?
Also a C224 is not a newer machine, its 11 years old.
Sounds like the 1 that "the drums are not turning" is behaving as it should be and the other machine is not.
Normal conditions are as follows:
- After a period of inactivity the machine goes in...
On the 2 & 3 series we had a lot of problems with fusers causing jams but so far none of that on the 4 series
For the tray 1/2/3/4 feed rollers, I find them to be pretty rubbish and usually fit a...
Guys,
The solution has already been posted, update the firmware to latest and do the following:
Function Settings > Prevent Miss-Sending Settings > Turn off the following: Destination Check...
Yes has issues with the "noise" when rebuilding 8 series drums, its almost like an electrical sound.
Thread on this below:
Bizhub C258 high pitch whine when copying/printing
Hi
Yes you are correct, latest firmware and then make those changes.
It cannot be done for this machine