You ever figure this out? This sounds like an issue a customer is having out in the field with a new one. haven't been able to reproduce it.
Type: Posts; User: mtgrizrich
You ever figure this out? This sounds like an issue a customer is having out in the field with a new one. haven't been able to reproduce it.
This ever get resolved? We are fighting the same
thing.
I got asked to stop by a potential clients office on a courtesy call to see I can get his copier going. He has a Kyocera Mita 2530. He has the message to set the eject tray. I am not familiar with...
Ok, thank you! How can it be cleared?
We had somebody call in with a Kyocera 2230 with a C0510 code. I am supposed to call him back with some advice. I am trained on Konica Minoltas and Lexmark. We are now a Kyocera Mita dealer, but I...
P51 is a front door open. Could be your front door switch.
Thank you very much emujo. But just to clarify, you mean the sd508 drive board, not the finisher c.b?
We are running into this same exact problem. How did you get this resolved?
We had this problem on a Bizhub 500. Copies were very light and developer was on the copies. We ended up getting a 2803. Turns out the toner hopper was bound up and wasn't adding toner. I had to...
I had a 2803 and found the toner addition solenoid was not energizing. Had to replace the printer control board and the toner addition solenoid (SD5), then had to flash it.
Not sure about the 450. The 460 motors are pretty much identical. The part number is different. I tnink one motor had a 10.3 amp rating while the other was a 10,4.
I got it. Apparently, the registration motor is getting weak. I swapped the registration motor and the paper feed motor and it works like a champ!
This is the same box as a Gestetner CP6334, Lanier LDD250, Ricoh HQ7000, and a Savin 3580DNP. It'll jam every 20-30 copies. With the "A" jams, the paper ends up between the registration rollers not...