Hi All
I have seen a post on the same jam code back some years but would like to post again on the jam code.
I have replaced the sensor and actuator, decurler roller, solenoid, mailers ,...
Type: Posts; User: MORGY
Hi All
I have seen a post on the same jam code back some years but would like to post again on the jam code.
I have replaced the sensor and actuator, decurler roller, solenoid, mailers ,...
A new main board was fitted. Had no problems at power on, only when logging in to admin mode and service mode.
All recommended steps in the service manual was followed however I can't access the...
Hi All
Initially the machine had a continous reboot fault. I then replaced the main board and upgraded the firmware. After power on the machine booted up fine and I was able to do copies, print...
Had the same fault on a c364e and fixed it with a new ssd and firmware.
Hi All
I have this bizhub popping this error C2226. I have cleaned all toner pipes, hoppers, sub hoppers and even tried replacing the the print controller board.
Toner bottle motor and pumps...
Thanks for the fix. Changed R1 clutch and all is good.
Is the error C2558 and not C2258?
Hi Freinds
Got the above error code after replacing the printer controller board. I checked the service manual and happen to find that it was a mismatch of firmware between the image controller...
Had the same fault on C280. Removed the toners and emptied and cleaned the sub toner hopper. Replaced developers and drums and all was good.
I am not sure of the cause of this but am suspecting...
Had that fault 2 x on the same machine, c6500. I changed the deve tank and developer yellow and it was fixed.
The second time I had the error code plus print quality issues which developer...
Hi
This firmware version should fix the error code / fault:
bizhub C658 Series Mass-Production Program Function Version4.0 (Ver. G00-Q)
Thanks...
There is a firmware that fixes this error code. I've done firmware updates on 2 x similar model machines with this same error and got it fixed.
Done! R1 clutch replaced with new problem solved.
Thanks everyone
Will do this and advise on the out come.
Hi All
I have the above machine set for user authentication. My client wants to print the reading out that will have every user count details. And since the main menu counter list only prints the...
Thanks all. I was able to get this job done.
Toner in the sub hopper must be completely empty. Remove sub toner hopper and clean the sensor inside plus the hopper itself. Make sure the sensor actuator is cleaned and free to move.
Put...
Hi All
IV2263N popping up error 092-315 every time copy / print of 6 - 10 pages is made.
I had to attend to this machine with the same error 4 months ago and was able to fix the machine by...
Hi
I have this jam code 9202 / 92-02 on a C6000. I have replaced a worn actuator ( adu actuator) cleaned sensors, rollers and tested all motors and clutches along the adu unit. I also cleaned...
I had the same issue with 3 x same models. I replaced all image units and was still the same. After firmware upgrade all was good.
Hi Everyone
Bizhub C6000 is printing dark maroon when the actual color is red. I did all the color calibrations for Fiery and Machine, loaded new fiery software and firmware, tested IDC sensors...
Will check this out...
Is the machine displaying a jam code?
Have you tried doing a Swap Test?
I had a similar jam code but it happened on FS-612 connected on to a Bizhub C1060. I fixed the fault / jam code by adjusting the By-pass Gate Solenoid ( SD5 ) on the finisher. Try adjusting the...