I was able to resolve issue... It was the laser power supply cable that was disconnected. Apparently that happened during transportation.
Type: Posts; User: nysamara
I was able to resolve issue... It was the laser power supply cable that was disconnected. Apparently that happened during transportation.
I was able to resolve issue... It was the laser power supply cable that was disconnected. Apparently that happened during transportation.
Probably 100 copies, It was a machine that was never used. It was stores in a non controlled room and transportation was not the best.
Sent from my iPhone using Tapatalk
I already changed DV. If I move the Yellow or Magenta PDCUs to the Cyan Location those PDCUs printing results are very good. However the Cyan which initially was printing good start failing in the...
Hi all! I purchased a used Ricoh c5200. It was never turned on, but when I finished installing it, it failed dems. I replaced the developer for all colors however it continue failing DEMS and Fulll...
I was able to identify that the issue is only with the Yellow and the Magenta. I was thinking that it may be an issue with the laser unit. I swapped the drum unit Y with the C and it perfectly...
I tried Full Music and it also Failed. However prints look good.
That may be the issue, it was stored in a not controlled room for a while.
It is without any doubt a new machine, I removed all the manufacturer tapes, and followed all the service manual instructions to assemble it. But obviously I’m just a person looking for help on this....
Hi all! I have a new Ricoh C5200, machine was purchased unassembled. I installed everything following the Service Manual but when I tried to do the DEMS it fails. Any clues?
Because we use it for production.
Hi all!
I have a Ricoh MPC8002, the Fiery stop working a few days ago and I had no other option than buying a E22C. Is there a way to reconfigure a Fiery E22C to use it in the 8002?
Counter was in 20K, I have the spare parts and will do it tomorrow. I measured the sensors and I had the yellow one activated. However It still have a little lubricant. But the strange thing was that...
Thanks!! By some reason... I had the error in the black unit but I did a reset to all units and it worked...
Sent from my iPhone using Tapatalk
Hi all!
I have a MPC8002 that started giving the message Replacement Required: Cleaning Unit for PCU for the Black. I verified the lubricant and there still lubricant. I even switched the cyan and...
It was a typo... I initially didn't had anything in the back display... it was off. Now it is normal... It is displaying "00".
Hi all! I corrected the problem. It was initially working erratically and then ended just turning the lights inside and not the rear display. I was able to correct it! I observed that the mother...
I configured the machine to run with the embedded controller. But I need it to run with the Fiery.
Sorry... with no numbers. The back display is just off...
Hi! Any update on this? I had the same issue 2 days ago... then I changed the ram to the other socket and it start working. Yesterday it stop working... I replaced the ram but I still dont have any...
Its is paper that I purchased 8.5 x 11... but this is only with the 300gms paper.
Sent from my iPhone using Tapatalk
One of the rubber blade that is under the developer unit fell to the Transfer Belt.
Sent from my iPhone using Tapatalk
I verified the belt and the fans and they look good... how ever I’m not sure if the fans are working... I think I will receive an error mesage if they are damage... right?
Hi!
I'm receiving this error each time I try to print using a 5.5x8.5" paper... I also received it printing the full page 8.5 x 11" the paper weight is 300gms but I also tried a 250gms and I had...
Issue resolved... there was something loose in the ID sensor...