Have not heard of lower cleaning mod. I Have widened the entrance gap on bottom of fuser and have had some success.
Type: Posts; User: bburp
Have not heard of lower cleaning mod. I Have widened the entrance gap on bottom of fuser and have had some success.
I had a similar issue with a DSPF. The width sensor was malfunctioning. It wanted to read A4 paper most of the time. It turned out to be a broken harness at the width sensor connector underneath the...
In 50-20 I would adjust the settings for Y till it got close to alignment. 50-22 should then be able to take over again. maybe also it is a bad y drum.
Finally someone else has seen the issue. I will try to find the bulletin on the sharp website.
Thanks
Sometimes scans have pages missing. We have turned on page counting for all scans. But sometimes when customer scans a file of x number of physical pages the MFP reports less pages.Cancel and retry...
Idea that worked once for us. We swapped the 2 motors for the output trays. Fingers crossed we have not had the issue for a while.
I believe dv units will interchange but I think process units will not fit
I have an M630 that will not copy or connect to network. Fax does not work also. No network lights. Will accept copies but not output them. Cannot print out reports No error codes on reboot. OP panel...
If the fuser rollers are in good condition, then the other 2 things I would look at is doing a color calibration( It may be putting too much toner on paper) and/or checking the fuser entrance and...
I don't know why my answer seems to work but is has worked for 3 small kyocera's and now a SHARP MX-5001. I inserted a small 4 port switch in the network line at the MFP. It now prints and I can...
The only issue that I have seen is if the customer will be using a VPN connection to connect to their home network. Some VPN's will not allow connected clients to use their local devices. These...